User manual HOLUX GPSMILE236

[. . . ] Not only transmit satellite information through the PDA or Notebook with Bluetooth interfaces but also is a G-Mouse GPS receiver through a data cable to deliver satellite signal to the device without Bluetooth interface. This positioning application meets strict needs such as car navigation, mapping, surveying, security, agriculture and so on. Only clear view of sky and certain power contacts to other device through Bluetooth supply are necessary to the unit. device, compatible interface of RS-232 or USB, and built-in recharge battery to save satellite information such as the status of satellite signal, the last location, date and time of last use. [. . . ] Protection circuit on should stop charging the cell when over-temperature condition --50 occurs. 4. 6. Output protocol Baud Rate 38400 bps Data bit 8 Parity No Stop bit 1 II. NMEA0183 V2. 2 GPGGA (1time/1 sec), GPGSA (1 time/5 sec. ), GPGSV (1time /5 sec. ), GPRMC (1time /1 sec. ), GPVTG (1 time/1 sec), (GLL, or SiRF binary format for optional). Compatible Bluetooth Serial Port Profile (SPP), Version1. 1 and class 2(up to 10 meter range). GPS signal (Out)/Command(In) with CMOS/TTL LevelMini USB Type B Connector and Cable option (a) GR230-A1(RS232 data cable) (b) GR230-A2 (USB data cable) (c) GR230-A3 (Mini USB port to PS2 port ). External Antenna interface: 3. 0V input MMCX type active antenna connector 4. 7. Physical Size 46. 3 × 67 × 19 mm Weight < 56 g Operating Temperature -10 to + 60 (under the un-charging condition); Charging Temperature 0 to + 45 Storage Temperature -20 to + 85 Operating humidity 5% to 95% No condensing 4. 8. Other Functions Bluetooth frequency: 2. 4 ~2. 48GHZ Bluetooth Input Sensitivity: -80dbm 6 HOLUX GPSlim236 Wireless Bluetooth GPS Receiver Manual Low sensitivity of receiving satellite signal -189 dBW External antenna interface: MMCX LED Functions Indicate Bluetooth status, GPS status, Battery Status and Battery charging status 7 HOLUX GPSlim236 Wireless Bluetooth GPS Receiver Manual 5. Charge Battery Please charge battery till LED off for the first time. Power cable plug in Charge Battery Battery indicator light: Power too low -------- red LED Charging -------------- green LED Full or Not in charging -- LED off Mini USB power socket Power cable connect to power socket STEP 2. Turn on Power Bluetooth Status ­ Turn on power No Searching Bluetooth device Yes Data is transferring?No Blue LED blinking (1time / 3 sec) Waiting for reconnection. . . No Blue LED blinking (1time / 1sec) Blue LED blinking No (1time / 1sec) Yes Note: Some PDAs have to re-open Bluetooth manager for Bluetooth device re-connection. GPS Status --Put in clear view of the sky without any obstruction for better satellite acquiring. Turn on power Turn off power Steady orange Search GPS -LED on Orange Position Fixed -LED blinking Power Off -Orange LED off 8 HOLUX GPSlim236 Wireless Bluetooth GPS Receiver Manual 5. 1. 2: LED of GPS (Orange) Bluetooth LED (Blue) Power Jack LED of Battery(Red / Green) (Fig. 2) 2). LED status : SYMBOL COLOR Blue Bluetooth Red Battery Green N/A Orange GPS 3). Light on Light on Light off Light on Blinking STATUS DESCRIPTION 1 times / 1 sec Search Bluetooth Device Blinking 1 time / 1 sec Standby Mode 1 time / 3 sec Transferring Data Power too low In charging Battery full or Not in charging Acquiring Satellites Position Fixed 9 HOLUX GPSlim236 Wireless Bluetooth GPS Receiver Manual 4). Optional accessories, and connector description, see Fig. PC/Notebook USB port PC/Notebook RS232 port USB Cable (GR230-A2) RS232 Cable (GR230-A1) Mini USB USB Cable (GR230-A2) (Fig. 3) 10 HOLUX GPSlim236 Wireless Bluetooth GPS Receiver Manual 3) External active antenna connector, see Fig. Active power voltage: 3. 0V (Fig. 5) 4) Power Jack & Data Port, see Fig. 6 Jack type: Mating face of 5 pin Mini USB Type B female Pin definition see table 1 1 (Fig. 6) Table 1 Pin Pin Name 1 2 3 4 GND VOUT TXD RXD Signal and description Signal ground, Battery charging ground. Unregulated voltage out: 3. 6 V max 100mA. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. [. . . ]