User manual HONEYWELL C7110CD1009

[. . . ] Twisted-pair wire is recommended for wire runs longer than 100 ft (30. 5 m). FEATURES Table 1. Features of the C7110C, D CO2 space temp. setpoint sensor sensor dial C7110C C7110D --LED CO2 level occupancy Removing Cover INSTALLATION The cover of the wall module is fixed in place using a tab located on the underside of the unit; to remove the cover from the subbase, see Fig. 1. The C7110D packages include two setpoint dials. [. . . ] When mounting directly on a wall, use the type of screws appropriate for the wall material. 2 for C7110C, D mounting dimensions. 2 LIFT 1 PRESS Fig. Registered Trademark Copyright © 2005 Honeywell Inc. · All Rights Reserved EN1B-0257GE51 R1105C C7110C, D WALL MODULES Fig. If the dial does not have the correct position, pull the dial off again and reinsert it with the correct orientation. 4 and make sure that the tab on the underside engages. 3-7/16 (86) 1234567 2-3/8 (60) 4 (100) 2-11/16 (68) 3-7/8 (97) 1-1/16 (27) 4-1/8 (104) 3-15/16 (99) 1-3/16 (30) Fig. Mounting cover of C7110C, D Wall Modules Fig. (mm) Wiring Mounting Procedure 1. Disassemble the cover as is shown in Fig. Remove the setpoint dial by pulling it off. a) Mount the wall module onto the wall outlet box, or b) bore wall holes as is specified in Fig. 2 and mount the wall module with appropriate screws. Connect the wires to the terminal block according to the specifications in section "Wiring". Insert the setpoint dial and turn it clockwise as far as possible. Make sure that the dial's position is such that the 30 (Celsius absolute scale) or the +5 (Celsius relative scale) point to the right-hand side of the wall module (see Fig. 3). Attach the wires from the device sensor terminals to the appropriate wall module terminals. IMPORTANT Screw type terminal blocks are designed to accept no more than one 16 AWG (1. 5 mm2) conductor. (5 mm) of insulation from the conductor. Insert the wire in the required terminal location and tighten the screw to complete the termination. 5. 1:COM 2:CO2 3:IN 24V 4:TEMP 5:SET PT 6:LED 7:BYPASS 1:COM 2:CO2 3:IN 24V 4:TEMP 5:SET PT 6:LED 7:BYPASS C7110C C7110D Fig. [. . . ] D): 4-1/8 3-15/16 1-3/16 in. Operating Temperature: 43. . . 104°F (6. . . 40°C). Shipping Temperature: -40. . . +150°F (-40. . . +65°C). Relative Humidity: 5. . . 95% non-condensing. Measurement range: 0. . . 2000 ppm (factory default); adjustable to 3000 ppm using UIP software kit Accuracy: ±100 ppm or 7% (whichever is greater) Elevation (Pressure) correction: Add 0. 13% of reading per mm Hg below 760 mm Hg (on-board correction, userset using UIP software) Response time, 0. . . 90%: < 5 min Warm-up time: < 2 min Agency certification: FCC Part 15 Class B, CE, California Energy Commission Power: · 18. . . 30 Vac rms, 50/60 Hz (half-wave, rectified) · 18. . . 42 Vdc (polarity protected) · 1. 75 VA max. [. . . ]