User manual HONEYWELL HM80

[. . . ] Temporary changes to the room temperature setpoint. Leave the cover folded out while reading further. Have all the work carried out by authorised qualified personnel. The Universal Mixing Valve Controller HM 80 is already assigned to the CM67RFMV at this set (no teach-in required). [. . . ] An additional flashing day marking shows the day of return. The holiday counter is reduced by 1 at each midnight until the set number of days has passed. the CM67RFMV then returns to the normal regulation MAN or AUTO , depending on the setting of the slide switch. In order to delete the HOLIDAY setting, press the button once more or move the slide switch. The value is adjusted faster if the button is kept pressed. The CM67RFMV regulates the set temperature for the set period and then returns to the normal program. Party again or move the slide switch in Press the button order to interrupt the party setting. In this operating mode the CM67RFMV activates the lower temperature limit of 5 °C. This ensures that the heating pipe work do not freeze up when it becomes colder. The CM67RFMV has a permanent memory in order to retain the program settings. Renewed programming after the battery has been replaced is not necessary. However, the time has to be corrected if you need more than a minute to replace the battery (see "Inserting batteries", Page 26). A symbol is displayed and the day marking for the following day flashes. This indicates that the Sunday program will be used on the following day. On the symbol is still displayed, however following day the without a flashing day marking. Interference of the radio receiver in the devices through metallic objects and further radio devices. Press the housing towards the wall until it snaps into place (2). Push the housing up (1), thus releasing (disengaging) it from the retainer. When selecting the operating site ensure that the distance to radio devices such as radio headphones, cordless phones, etc. According to the DECT standard amounts to at least 1 m. Ensure that there is sufficient distance (> 30 cm) to metallic objects. Select another installation site if the radio interference cannot be rectified. [. . . ] Depending on the heat requirement of the installed rooms the relay module HC60NG/R6660D controls the heat generator as a function of the valve setting. Press the button at the relay module HC60NG/R6660D for 5 seconds in order to activate the mode. The relay module HC60NG/R6660D is switched on and off depending on the room temperature setpoint/actual value. Recognition of the flow temperature sensor takes place automatically as soon as a sensor is connected. [. . . ]