User manual HONEYWELL HR80

[. . . ] First read through all the steps for the complete binding procedure and then carry them out. Set temperature Symbol for actual value coming from the command centre (optional). Position the operating unit directly near the corresponding One second and then release it. When the binding procedure button is released, the symbol flashes and the software version number is displayed for 30 seconds. [. . . ] Pull operating unit and coupling module apart from each other Counterclockwise until the nose (1) of the adjustment dial is positioned at the stop (2) of the housing (Fig. Push coupling module onto the radiator valve (Fig. The operating unit and coupling module are connected firmly. In order to change between the two operating modes, press the binding procedure button (1, Fig. The HR 80 operates with the optimum valve lift that is required for room temperature control. If the complete valve lift is to be used or if the valve does not close completely, you have to set the HR 80 to the full operating mode. Before screwing the radiator controller onto another valve: Separate the valve lantern from the operating unit. Every local change in the setpoint temperature remains valid until a time program overwrites it automatically. Insert the batteries again while keeping the binding procedure The set temperature is controlled by the command centre and set there as well. For further information please refer to the operating instructions of the command centre. 1 Changing set temperature with adjustment dial Turn the adjustment dial of the operating unit until the desired set temperature (between 5 ­ 30 °C) is displayed. The range for the set temperature (standard range: 5 ­ 30 °C) can be restricted at the command centre. In order to open or close the radiator valve completely: Turn the adjustment dial until "OFF" (closed) or "ON" (opened) is displayed. (If temperature limits are set, "ON"/"OFF" is not displayed. If the symbol e3 is shown on the display, the motor of the HR 80 can no longer be moved. The following adapters/coupling modules are available for Oventrop, Herz, Danfoss, Vaillant and Caleffi valves: Coupling module type Order name Oventrop HU 01 (Fig. If Batt appears in the display, both batteries must be replaced (see Section 2. If the batteries are too weak, the radiator controller opens the radiator valve completely. If the batteries are replaced after the binding procedure has been completed, is displayed. The radiator controller waits for data from the command centre. [. . . ] Turn adjustment dial two full rotations (720°) further. The radiator controller transmits a test message to any available receiver unit (e. The radiator controller is ready to receive the test message from the command centre. The first two digits in the display indicate the number of received test messages, and the right-hand digit indicates the field strength (1 = sufficient field strength, 5 = very good field strength) To deactivate Service mode: Press the binding procedure button for 5 seconds or wait 5 minutes or remove and then reinsert the batteries. [. . . ]