User manual HONEYWELL HRD 80

[. . . ] Contents Overview Operating elements Button assignment Assigning buttons Assigning additional buttons Changing button assignment Controlling Hometronic with the remote control Example assignment of the buttons Controlling illumination (button 1) Controlling shutters (button 2) Lowering and raising setpoint temperature (button 3) Activating "Evening" lifestyle (button A) Locking remote control (child-proofing) Inserting/changing batteries Technical data Help with problems 21 22 23 24 24 29 29 30 31 31 32 33 34 35 36 37 37 With the HRD 80 Remote Control, you can · Switch control units on and off or dim lights · operate shutters and awnings · Raise or lower the setpoint temperature of a room · Activate lifestyles Any number of remote controls can be used with the Hometronic. The remote control can be locked (child-proofing) with a simple button combination. [. . . ] Select component according to your assignment table (step 1). You can change the assignment of individual buttons at any time (see "Assigning additional buttons"). You can control the Hometronic with the remote control once button assignment has occurred: To select a component or lifestyle: Press one of the buttons 1­6 or A or B. The LED flashes and then illuminates green again. The selected component remains active until the LED goes out (approx. 15 seconds) or another component is selected. If the Hometronic is in automatic mode, changes made with the remote control are only retained until the next switching point. A typical button assignment is assumed in the following explanation: Button 1 Controls the illumination Button 2 Controls the shutters Button 3 Controls the setpoint temperature of the living room Button A Activates the "Evening" lifestyle For information on how to change this (max. You can lock the remote control to prevent unauthorised operation: Press the , and ok buttons simultaneously. The remote control is ready for use once again. Change the batteries as soon as the LED of the remote control illuminates red or not at all when buttons are pressed (an exception to this is when the remote control is locked; the LED flashes. Insert new batteries, paying attention to correct polarity. [. . . ] The declaration of conformity of the product can be requested from the manufacturer. Note to non-EU countries: This product may only be used if operation in the 868 MHz frequency band is permissible. [. . . ]