User manual HONEYWELL MN12CES

[. . . ] #Canada Customer Support service available for models sold in Canada only. Congratulations on your purchase of this versatile Honeywell Portable Air Conditioner. uSER TIPS Honeywell Portable Air Conditioners are ideal for spot cooling. The compressor, condenser and evaporator are housed in a compact unit. [. . . ] Continuous drainage is then necessary and more efficient (refer to Continuous Draining). TIMER CONTROL While the unit is turned on, press the timer button then press the À or · To select the number of hours you would like the unit to continue to run. AUTO TURN OFF: While unit is running, press the press the À or · Button to select the number of hours you want the unit to run in air conditioning mode. AUTO TURN ON: When unit is in a standby mode (plugged in with power light on), then press the À or · Button to select the number of hours until you want the unit to automatically start running. tEMPERATURE / TIMER SET CONTROLS · Used for adjusting the timer and thermostat. The default display is room temperature. Button is pressed, the set temperature is displayed and may be adjusted. After 10 seconds the display will revert back to room temperature. temperature is only adjustable in cool mode. The time is adjustable between 1~24 hours. note: By pressing both À/ · Set buttons at the same time, the display will toggle between Celsius and Fahrenheit. WARNING LIGHT Condensed water may accumulate in the unit. If the internal tank becomes full, the Power Control light will flash and the unit will not operate until the unit has been drained (refer Water Condensation Drainage). After switching the air conditioner off, you must wait 3 minutes before switching it back on again. *Applicable for models with Heating feature only. REMOTE CONTROL The functions work the same as the portable air conditioner's Touch Screen Control Panel. All key functions can be accessed from the remote control. Timer Control In running mode: Auto switch off In stand-by mode: Auto switch on Press À or · Button to adjust the time setting for 1 hour intervals. Used for adjusting the timer and temperature. Key is pressed in cool mode, the set temperature is displayed and may be adjusted. After 10 seconds the display will revert back to room temperature. Timer setting is available from 1-24 hours by pressing the key À or · Press this button to change the operation mode in the order of: *Applicable for models with Heating feature only. [. . . ] When there is excess water condensation inside the unit, the air conditioner stops running and shows a warning light (the Power Control button flashes with a red light). This warning light indicates that the water condensation needs to be drained using the following procedures: Manual Draining for AC & Dehumidifier Mode Water may need to be drained in high humidity areas. Remove both the plastic cap and lower drain plug. Water will drain out and collect in the shallow pan. [. . . ]