User manual HONEYWELL T7270A2001

[. . . ] T7270A2001 See the W7070A2000 ZAPP Receiver Installation Instructions (EN1B-0396GE51) for information on installing wireless systems. APPLICATION The T7270A2001/T7270A2019 ZAPP Wireless Wall Modules are used for intelligent room temperature control. · The T7270A2019 ZAPP Wireless Wall Module measures the room temperature and transmits the measured values to the W7070A2000 ZAPP Wireless Receiver. · The T7270A2001 ZAPP Wireless Wall Module measures the room temperature and transmits the measured values to the W7070A2000 ZAPP Wireless Receiver. [. . . ] Allocate the corresponding temperature zone to the T7270A2001/T7270A2019 see System Engineering (EN0B-0286GE51) for information on the "teach-in" procedure. Drill the holes. Place the housing cover in position above and snap it down (see Fig. 5). Failed Teach-In If the teach-in has failed: Improve the data transfer (see below). Improving the data transfer When selecting the operating site of each device, ensure that the distance to radio devices such as radio headphones, cordless phones, etc. according to the DECT standard amounts to at least 1 m. Do not install the devices over metallic wall connecting sockets and at least 30 cm away from the cover of the heat generator. Correct the installation site of the devices, if necessary. Please see also System Engineering (EN0B-0286GE51). Replacing housing cover De-Teaching Devices For more information about de-teaching individual (or all) devices, please see System Engineering (EN0B-0286GE51). EN1B-0397GE51 R1207A 2 T7270A2001/2019 WIRELESS WALL MODULE SPECIAL FEATURES OF T7270A2001 Operation The room setpoint temperature can be set easily at the T7270A2001 using its adjustment wheel. The adjustment range amounts to ± 12 °C, starting from the basic value of 20 °C (in position 0). Fig. T7270A2001 Select the desired change of the preset temperature at the adjustment wheel (1) (see Fig. 6) (scale in °C). Limiting the Adjustment Range You can limit the setting range that can be used at the adjustment wheel. Limiting the adjustment range Place the two small pins into the holes of the adjustment wheel in order to limit the adjustment range (see Fig. Orientate yourself on the basis of the inner scale: In Fig. 7, the pins are inserted so that the adjustment wheel can only be adjusted by ±3 °C around the zero point. Turn the adjustment wheel clockwise until it stops. Check whether the adjustment wheel is in the position shown in Fig. If appropriate, put the adjustment wheel back in, rotated by 180°, until it has the position shown. [. . . ] If appropriate, repeat. Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route du Bois 37, Switzerland by its Authorized Representative: Honeywell GmbH Böblinger Straße 17 71101 Schönaich, Germany Tel. : (++49) (0) 7031 637 01 Fax: (++49) (0) 7031 637 493 http://europe. hbc. honeywell. com Subject to change without notice. Printed in Germany This document is definitive for the enclosed product and replaces all previous publications. hereby declares that this device complies with the basic requirements and other relevant regulations of guideline 1999/5/EC. [. . . ]