User manual HONEYWELL V5822A DATASHEET

[. . . ] SMALL LINEAR VALVES PN16 FOR MODULATING AND ON/OFF-CONTROL SPECIFICATION DATA V5822A/5823A, C FEATURES · · · · · · V5822A V5823A Small size allows installation where space is limited Range of fittings available for different connections (compression, soldered, threaded) Long stroke results in a high-quality characteristic Soft seat provides low leakage rate and high rangeability Reduced kVS values in the bypass to facilitate hydronic balancing Adjustment cap for manual operation Valve inserts changeable without draining by using insert replacement tool WV 108 Compatible with two-piece conex compression fittings Conical sealing connections Flat surfaces on body to fit installation tools 40 mm distance between ports A/AB and the bypass (V5823C, only) · · · · · V5823C SPECIFICATIONS Models Two-way V5822A Three-way V5823A Three-way with bypass V5823C Two-way stem up to open, port A to B; Three-way stem up to close, port A to AB PN16 see tables on page 2 and 3 0. 02% of kVS Brass DN15 (1/2"), DN20 (3/4") Stainless steel Brass Water, with max. 50% glycol 2. . . 120 °C GENERAL These small linear valves are used in combination with small electric linear valve actuators and thermoelectric actuators for the control of hot and/or chilled water for fan coil units and small reheaters/recoolers in electric/electronic temperature control systems. Operation Nominal pressure rating Capacity index (kVS) Leakage rate Valve body Material Size Trim Stem Plug Suitable medium Controlled water temperature ® U. S. [. . . ] This allows the stem to be set up for filling or initial heating/cooling during the building construction phase without the use of a controller or actuator. The small electric valve actuators as well as the thermoelectric actuators provide automatic control over the opening and closing movement of the valve stem. Three-Way Valves These valves are preferably used as mixing valves, this means: Port AB: Total flow outlet Port A: Controlled flow inlet Port B: Bypass inlet inlet + - inlet + - AB A B AB B A TYPICAL OPERATION All types of valves should be mounted in the return flow. If the p-values exceed 60 kPa, attention should be paid to the development of noise. Fig. Three-way valve operation Two-Way Valves Direction of flow always from port A to port B Port B: Outlet Three-Way Valves with Bypass These valves simplify the installation, which is depending on the layout of the pipework, as the bypass pipe is part of the valve. The information for the normal three-way valves is also valid for this type. + - inlet + outlet outlet inlet inlet + - inlet + - AB B A AB B A Fig. Three-way valve with bypass 3 EN0B-0307GE51 R0209 V5822A/V5823A, C SMALL LINEAR VALVES PN16 MOUNTING When installing the valve care must be taken that the flow direction is correct (see section "Typical Operation"). The valve must not be mounted with the stem pointing downward. The adjustment cap must be removed from the valve only when the actuator is fitted. The valve should be installed as stress-free as possible with a tightening torque of 25 to 30 Nm. The valve is supplied complete with mounting instructions. The water quality must meet VDI 2035 requirements. ACCESSORIES For valves V5822A, two connection sets are necessary; for valves V5823A, three connection sets are necessary; for valves V5823C, four connection sets are necessary. Connection Compression Pipe Size 15 mm 22 mm 12 mm 15 mm R3/8" R1/2" 15 mm 22 mm DN 15 20 15 20 15 20 15 20 Order Number ACN-15C ACN-20C ACN-15S ACN-20S ACN-15T ACN-20T 63* 65* Connection Set Description Consisting of 1 union nut and 1 ferrule Consisting of 1 union nut and 1 solder bush Consisting of 1 union nut and 1 tailpiece Capnut and compression ring Soldering External Thread Compression (Conex) *Cannot be purchased from Honeywell Dimensions of Connection Sets a G1/2" 11/8" x 14 BS 84 G1/2" 11/8" x 14 BS 84 b 15 mm 22 mm 12mm 15mm c d Order Number ACN-15C ACN-20C ACN-15S ACN-20S G1/2" 11/8" x 14 BS 84 R3/8" R1/2" ACN-15T ACN-20T EN0B-0307GE51 R0209 4 V5822A/V5823A, C SMALL LINEAR VALVES PN16 DIMENSIONS Two-way valve 6. [. . . ] Order Number V5822A1006 V5822A1014 V5822A1022 V5822A1030 V5822A1048 V5822A1055 V5822A1063 V5822A1071 V5822A4000* V5822A4018* * For on/off control Order Number V5823A2003 / V5823C2009 V5823A2014 / V5823C2017 V5823A2029 / V5823C2025 V5823A2037 / V5823C2033 V5823A2045 / V5823C2041 V5823A2151 / V5823C2058 V5823A2052 / V5823C2157 V5823A2169 / V5823C2066 V5823A2060 / V5823C2165 V5823A4009* / V5823C4005* V5823A4017* / V5823C4013* * For on/off control DN 15 15 15 15 15 20 20 20 20 15 20 kVS 0. 25 0. 40 0. 63 1. 00 1. 60 2. 50 2. 50 4. 00 4. 00 1. 60 2. 50 Order Number Valve Insert 0902821 0902822 0902823 0902824 0902825 0902826 0902818 0902827 0902819 0902817 0902820 DN 15 15 15 15 15 15 20 20 15 20 kVS 0. 16 0. 25 0. 40 0. 63 1. 00 1. 60 2. 50 4. 00 1. 60 2. 50 Order Number Valve Insert 0902812 0902811 0902810 0902809 0902808 0902807 0902814 0902815 0902813 0902816 The following valve inserts are interchangeable · Two-way valves: kVS 0. 16, 0. 25, 0. 40, and 0. 63 kVS 1. 0 and 1. 6 kVS 2. 5 and 4. 0 kVS 0. 25, 0. 40, 0. 63, and 1. 0 kVS 2. 5 and 4. 0 · Three-way valves: Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Rolle, Z. A. La Pièce 16, Switzerland by its Authorized Representative: Automation and Control Solutions Honeywell GmbH Böblinger Strasse 17 71101 Schönaich Germany Phone: (49) 7031 63701 Fax: (49) 7031 637493 http://ecc. emea. honeywell. com Subject to change without notice. [. . . ]