User manual HOOVER AM 110

[. . . ] This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes. Q Do not touch the appliance with wet or damp hands or feet. Q Do not use the appliance when bare-footed. Q Extreme care should be taken if extension leads are used in bathrooms or shower rooms. [. . . ] A) Turn the nut clockwise to release the screw adjuster of the foot. B) Rotate foot to raise or lower it until it stands firmly on the ground. C) Lock the foot in position by turning the nut anticlockwise until it comes up against the bottom of the machine. After installation, the appliance must be positioned so that the plug is accessible. Detergent drawer Door open button Off/On button "Express Wash" button Rinse hold button Extra rinse button 1300/600 button Wash control temperature knob Timer knob for wash programmes Door locked indicator light DOOR LOCKED INDICATOR LIGHT Door locked indicator light is illuminated when the door is fully closed (only after that On/Off button is pressed). At the end of the cycle, when the light will go out is possible to open the door. "EXPRESS WASH" BUTTON By pushing this button the time of the wash programme is reduced to a maximum of 50 minutes depending on the programme and the temperature selected. The Express wash button can be used for washing loads of 1 to 4, 5 kg. (This button can be utilised only on cottons and synthetic programmes). EN RINSE HOLD BUTTON The "Rinse hold" function minimizes creases as much as possible with a uniquely designed anti-crease system that is tailored to specific fabrics. MIXED FABRICS - the water is gradually cooled throughout the final two rinses with no spinning and then a delicate spin assures the maximum relaxation of the fabrics. We found only one brand always lives up to our exacting standards and provides outstanding cleaning across a broad range of dirt and stains, as well as providing high levels of fabric care. That's why Hoover gave Ariel their official seal of approval. A guide environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE To prevent any possible waste of energy, water or detergent we recommend that you put a full load in your washing machine, not exceed the maximum loads shown below: Cotton and linen 4, 5 kg Mixed 2 kg Very delicate 1, 5 kg Wool 1 kg Save up to 50% energy by washing a full load instead of 2 half loads. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme. This washing machine automatically adapts the level of the water to the type and quantity of washing. In this way it is also possible to obtain a "personalized" wash from an energy saving point of view. This system gives a decrease in energy consumption and a sensible reduction in washing times. The maximum load for heavy fabrics is 4, 5 kg, while, in the case of delicate fabrics, it is advisable not to exceed 2 kg (1 kg in the case of machine washable articles in "Machine Washable Woolens") so as to avoid the formation of creases which may be difficult to iron. [. . . ] Repeat the same operation with the water inlet hose. Does not function on any programme CAUSE Mains plug not plugged in Mains switch not on No power Electric circuit fuses failure Load door open Insert plug Turn on mains switch Check Check Close load door Check Turn on water inlet tap Set timer on correct position Straighten discharge tube Check filter Replace washer and tighten the tube on the tap Wait a few minutes until the machine discharges water Turn the programme dial onto spin setting Adjust special feet Remove transport bracket Distribute the washing evenly See cause 1 Inlet tap turned off Timer not set correctly Discharge tube bent Odd material blocking filter Leak from the washer between the tap and inlet tube The washing machine has not discharged water "No spin" setting (some models only) Strong vibrations during spin Washing machine not perfectly level Transport bracket not removed Washing load not evenly distributed Please note: It is normal for the programme selector dial to move only from one stage of washing programme to another and not show any movement in-between ­ so at certain periods, the dial will stay still. For prompt servicing, give the model of the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the guarantee certificate. Important 1 The use of environment friendly detersives without phosphates may produce the following effects: - The discharge rinse water may result cloudier due to the presence of zeolites in suspension. [. . . ]