User manual HOOVER F 38 PQ

[. . . ] Fit the handle into the socket at the rear of the hood and push until it locates in the hole (indicated by a "click") (Fig. Once the bag support is attached, insert plastic flange at the bottom of bag into the opening located at the rear of the hood (Fig. (Depending on model) Refer to the following instructions for models equipped with paper dust bag: 1) Open fastener on outer bag to the fullest extend to expose the air-duct. [. . . ] They should used after the Black soft bristle brushes. Remove any greasy stains using a damp cloth. To apply the polish, follow the instructions supplied with the polish. Use a good quality polish, spreading it evenly. After the polish has dried, polish the floor with the yellow hard texture brushes or the softer black brushes. For producing a high gloss, use the natural white pads for wooden floors or grey buffing pads for all other hard surfaces. To obtain better results, always move the polisher in straight lines rather than in circles. Buffing pads should only be used after the whole surface has first been polished with brushes. To maintain the efficiency of your polisher check the dust level and empty the cloth bag or replace the paper dust bag frequently. Fully open zip fastener and remove paper dust bag by pulling the cardboard collar from the air duct (Fig. Fit new paper dust bag as described in paragraph "Fitting the paper dust bag". On these models the red light will switch on when paper dust bag needs to be replaced. 8) and disconnect bottom plastic flange from hood pressing lightly on the indent on the flange. Turn cloth bag upside down and shake gently (Fig. We suggest hand washing it in warm water with a mild detergent. Brushes may be washed in warm water with a mild detergent. Pads may be gently brushed with soapy water and wiped with a damp cloth. do not immerse the pads in the soapy water. [. . . ] Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]