User manual HOOVER FLOORMATE

[. . . ] When using an electrical appliance, always follow basic precautions, including the following: READ ALL INSTRUCTIONS BEFORE USING APPLIANCE. Use only on surfaces moistened by the cleaning process or small spills. For use on bare floors or sealed wood floors. Always install float before any wet pick up operation. [. . . ] ) HOOVER® Floor to FloorTM Cleaner. Check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor. When cleaning ceramic and other tiles, use the set of grout brushes with gray bristles included with your FloorMateTM SpinScrubTM 800 Cleaner. Use these for tile floors where extra attention is needed for cleaning grout. CAUTION: HOOVER® Floor to FloorTM Cleaning Concentrate and HOOVER® Grout Cleaner cannot be used in Hoover SteamVacTM products. Doing so could damage your SteamVacTM Cleaner. 23 C 23 Pour cleaning concentrate into tank (B). Fill tank to fill line (C) (1 quart) with warm water. If rubber ring (D) on cap has become dislodged, reposi24 tion it with uneven side against ledge (E) as shown. Cap must be locked in place for proper performance and to prevent leaking. 26 Slide tank straight into position until latch snaps in place. Automatic shut-off An automatic suction shut-off is built into the recovery tank to prevent the tank from overflowing. When the shut-off activates, the cleaner will not pick up debris and the sound of the motor will change. How to empty 27 B Turn cleaner off and disconnect from electrical outlet. Although not necessary for satisfactory performance, it is recommended that the recovery tank be emptied after dry vacuuming and before wet operation. It may need to be refilled at this time. To remove tank, press down on release button (B) 27 and pull tank straight out. Clean this pleated filter when suction is low or reduced. Turn cleaner OFF and disconnect from electrical outlet. Remove loose debris from filter by tapping the filter or gently brushing using your hand. the filter may also be rinsed for additional cleaning. Press down firmly until snapped in place. [. . . ] Tip nozzle off floor by pushing down on handle to pick up debris that is too large to clear the squeegee. Make sure solution tank is locked in position. refill the solution tank if it is empty. Pump needs to be primed (when using tool). [. . . ]