User manual HOOVER STEAMVAC DUAL V CARPET CLEANER

[. . . ] Please review this manual before operating your Hoover® product. Please enter the complete model and serial numbers in the spaces provided. Hint: Attach your sales receipt to this owner's manual. Verification of date of purchase may be required for warranty service of your HOOVER product. [. . . ] When cleaning entire floor, move furniture out of area to be cleaned (may not be necessary if only high traffic areas are to be cleaned). For furniture too heavy to move, placealuminumfoilorwaxpaperunder legs. This will prevent wood finishes from staining carpet. Pretreat spots and heavy traffic areas with HOOVER®Spot&StainSprayCleaner*-FollowDirectionsonbottle. To prevent staining, use plastic or aluminum foil to protect wood or metal surfaces from possible water spray. To avoid wetting and possible damage to wood floors underneath area rugs/carpet, either move area rugs/ carpet to a non-wood hard floor surface or place waterproof material (e. Read "Before you begin cleaning" instructions on page 13. Fill clean water tank according to instructions for Figs. Fill detergent container with Hoover Carpet/UpholsteryDetergentaccordingto instructions for Figs. Do not clean over floor electrical outlets. To avoid walking on damp carpet, start at the end of the room farthest from the door or path to sink where tanks will be emptied and filled. Step on handle release pedal and lower handle to operating position. Squeeze trigger to apply cleaning solution and slowly push cleaner forward (equals one wet stroke). Continue to squeeze trigger and slowly pull cleaner back toward you (second wet stroke). the cleaner rinses the carpet on the backward pass (on Auto-Rinse only). Note: To assure proper rinsing, it is important to keep the cleaner on the same path backward as forward. Release trigger and slowly push cleaner forward over area just sprayed with solution (dry stroke). Then slowly pull cleaner back toward you without squeezing trigger (dry stroke). Continue using dry strokes until little water is visible passing through the recovery tank lid. Overlap strokes by 1 inch to help prevent streaking (Pass over the same area a minimum of 4 times = 2 while squeezing the trigger and 2 without). If you would like to rinse the carpet with water only, set Rinse Setting switch to RINSE (Fig. In this setting, rinsing will be done on both forward and reverse strokes. [. . . ] Agitator brushes will not rotate while handle is in upright position. Fill clean water tank according to instructions for Figs. Fill detergent container with HOOVER Carpet/UpholsteryDetergentaccording toinstructionsforFigs. Donotuse hard floor cleaning solution when cleaning upholstery. [. . . ]