Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HORSTMANN ELECTRISAVER E30. We hope that this HORSTMANN ELECTRISAVER E30 user guide will be useful to you.
Lastmanuals help download the user guide HORSTMANN ELECTRISAVER E30.
Manual abstract: user guide HORSTMANN ELECTRISAVER E30
Detailed instructions for use are in the User's Guide.
[. . . ] USER INSTRUCTIONS
To use the Electrisaver simply press the BOOST button in quick succession until the indicator light for the required boost period is illuminated (see table below).
BOOST PERIOD
PRESS BOOST BUTTON TO SELECT LENGTH OF REQUIRED BOOST. BUTTON PRESS Electrisaver E15 Electrisaver E30 #1 15min 30min #2 30min 1 Hour #3 60min 2 Hour
To cancel a boost period press the BOOST button continuously until ALL the indicator lights are OFF. [. . . ] In some cases immersion heater failure can damage the Electrisaver. Installation of a 100 mA RCD will provide additional protection for the unit. If the Electrisaver is to be connected to a ring main then the spur feeding the controller should be protected in the same way. The Electrisaver is NOT suitable for mounting on an unearthed metal surface.
LEAFLET No P80502 ISSUE 3
Email: sales@horstmann. co. uk Website: www. horstmann. co. uk
Horstmann Controls Limited Bristol BS4 1UP
Page 4
Page 1
CONNECTIONS SURFACE WALL MOUNTING
Use twin and earth cable with a minimum conductor size of 2. 5mm2 to connect the Electrisaver to the supply. Use a suitably rated three-core flexible cord (see below) to connect the Electrisaver to the appliance to be switched. For appliances up to 2Kw rating use minimum 1. 0mm2 conductors. For appliances up to 3Kw rating use minimum 1. 5mm2 conductors. The Electrisaver is suitable for mounting directly on to any surface mounted single gang moulded box having a minimum depth of 28mm. Cable entry being through the most convenient cut-out. Heat resistant flexible cord must be used if connection the Electrisaver to an immersion heater. Connections to the Electrisaver terminal block should be as follows:N in N out L in L out = = = = N EUTRAL in N EUTRAL out to appliance LIVE in LIVE out to appliance
FLUSH WALL MOUNTING
The Electrisaver can be mounted directly to any standard 35mm deep flush mounting single gang wiring box complying with BS4662
Remove cut-outs before fixing the box. Where appropriate drill the box to provide close fitting entry for cables and heat-resistant flexible cords. [. . . ] Do not damage insulation or trap the conductors during this operation. Finally switch on the mains supply, ensure the Electrisaver operates correctly.
Page 3 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HORSTMANN ELECTRISAVER E30
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HORSTMANN ELECTRISAVER E30 will begin.
