User manual HOTPOINT-ARISTON HB71360

[. . . ] Keep this booklet in a safe place for further reference when required. Oven accessories which may come into contact with food are made of materials which comply with the contents of EEC Regulation 89/109 of 21. 12. 88 and national regulations in force. After having removed the packaging, check that the appliance is intact. If in doubt, do not use the appliance and contact professionally qualified personnel. [. . . ] The oven heats up very quickly so the food to be cooked may be put into the oven as it is switched on. Cooking is also possible simultaneously on both shelves. · The "fast defrosting" function uses no heating elements, just the oven light and the fan. fig. 3a 4 fig. 3b AUS HOW TO KEEP YOUR OVEN IN SHAPE Important: The appliance should be disconnected from the mains supply before starting cleaning operations. To ensure a long life cycle for the appliance, it is essential to carry out a thorough general clean frequently, while observing the following instructions: Inside the oven door: Clean the surface with a cloth moistened with hot water and non abrasive liquid detergent, then rinse and dry thoroughly. Inside the oven: · The inside of your oven is coated with a special selfcleaning microporous enamel glaze which, at a normal cooking temperature of between 200 and 300°C, oxidises and completely eliminates all grease spots or other substances that inevitably attack the inner walls of the oven. This way, cleaning is kept right down to a minimum: as a matter of fact, you just need to rub the surfaces of the oven with a wet cloth regularly, after cooking, to remove the thin layer of ash that may have been deposited during cooking, in order to maintain the selfcleaning property of the oven intact. · After cooking where liquid has overflowed or when the dirt has not been eliminated completely (for example when grilling food, and the temperatures reached are not high enough for the full self-cleaning action of the enamel to be performed), we recommend you leave the oven on at maximum temperature so that all grease residue and the like are eliminated. · If, after long-term use, you find evident grease stains deposited on the self-cleaning oven walls, probably due to your failing to follow the above maintenance advice, clean the surfaces thoroughly with hot water and a soft cloth (do not use any detergents), then rinse and dry thoroughly. · Do not remove any dry caked-on grease using sharp objects, as these could etch the self-cleaning coating. · If the self-cleaning surfaces inside the oven are damaged or worn, due to incorrect or poor maintenance or after many years of use, you can request a kit of self-cleaning panels to line the inside of the oven. To order these, just contact an authorised Service Centre. At this point, the oven will turn on automatically at 12:30 in order to finish the cooking session within 30 minutes. When the oven is on, the symbol (cooking pot) will appear on the display for the entire length of the cooking process. The button can be pressed at any time to display the setting for the length of the cooking time, while the button can be pressed to display the end cooking time. At the end of the cooking time, an acoustic signal will sound. Press any button it turn it off (except the - and + buttons). Immediate Start Time with Preset Cooking Length When only the length of the cooking time is set (points 1 and 2 of the paragraph entitled, "Delayed Start Time with Preset Cooking Length"), the cooking session starts immediately. Cancelling a Preset Cooking Time Press the button, and use the - button to set the time to: Then press the manual cooking mode button . Timer Feature The timer can be used to count down from a given length of time. This feature does not control when the oven comes on or turns off, but, rather, it only emits an acoustic signal when the preset time has run out. button, and the display will read: Press the Then use the - and + buttons to set the desired time. Release the button, and the timer will start at that second. The display will show the current time. At the end of the preset time, an acoustic signal will sound, which can be turned off by pressing any button (except the - and + buttons), and the symbol will turn off. [. . . ] Make sure that the natural gas pipe is adequate for a sufficient supply to the appliance when all the burners are lit. Important: A pressure regulator, in compliance with the standards in force, must be inserted when connecting to a liquid gas supply (in a cylinder). Adaptation to a different type of gas If the hob is to be converted for use with a type of gas other than that for which it was set in the factory (indicated on the label to be found on the hob), the burner nozzles should be replaced as follows: · Remove the pan supports and the burners. · Unscrew the nozzles "A" (fig. 10) using a 7 mm socket wrench and replace them with the ones which have a diameter suitable for the type of gas to be used, according to the table 1 "burners and nozzles specifications). [. . . ]