User manual HOTPOINT 7OFH 620

[. . . ] wARNING: THIS WARNING IS APPLICABLE FOR USA ONLY. If used in USA, use the UL LISTED power cord specified below. Plug Cap Parallel blade with ground pin (NEMA 5-15P Configuration) Cord Type SJT, three 16 or 18 AWG wires Length Minimum 1. ) Rating Minimum 10 A, 125 V Using this unit at a voltage other than 120 V may require the use of a different line cord or attachment plug, or both. [. . . ] â· Use of alcohol, benzene, thinner or insecticide may damage the finish of the cabinet or remove the indications on the cabinet. To obtain the best picture, the front of the screen should not be exposed to direct lighting or sunlight. Use a cover over fluorescent lamps to avoid lowering the contrast ratio. â· Cover any windows that face the screen with opaque draperies. â· It is desirable to install the unit in a room where floor and walls are not of lightreflecting material. If the floor and walls are of reflecting material, it is recommended that the carpet and wall paper be changed to a dark color. If you rub on the cabinet with a stained cloth, the cabinet may be scratched. â· If the cabinet is in contact with a rubber or vinyl resin product for a long period of time, the finish of the cabinet may deteriorate or the coating may come off. Do not install the projector in the following situations. Installation is these situations or locations may cause a malfunction or damage to the unit. This LCD data projector is manufactured using high-precision technology. Avoid using a thick-piled carpet or anything that covers the ventilation holes (exhaust/ intake); otherwise, internal heat may build up. Note on carrying the projector The unit is manufactured using highprecision technology. When transporting the unit stored in the carrying case, do not drop the unit or subject it to shock, as this may cause damage. When storing the unit in the carrying case, disconnect the AC power cord and all other connecting cables or cards, and store the supplied accessories in a pocket of the carrying case. Note on the screen When using a screen with an uneven surface, a striped pattern may rarely appear on the screen depending on the distance between the screen and the projector or the zooming magnification settings used. This is not a malfunction of the projector. Do not place a blocking object just in front of the lens Do not place any object just in front of the lens that may block the light during projection. Heat from the light may damage the object. Use the PIC MUTING key to cut off the picture. Use the Security bar at the rear of the projector for a purpose of preventing theft, by attaching a commercially available theft prevention cable for example. If you lift the projector by holding the Security bar, or hang the projector by using this bar, it may cause the projector to fall or be damaged. [. . . ] Note Be sure that the projector is stable after turning it over. Insert the new lamp all the way in until it is securely in place (a). 12 Select "Execute" with the V key, and Be careful not to touch the glass surface of the lamp. â· The power will not turn on if the lamp is not secured properly. [. . . ]