User manual HOTPOINT AMXXL 129

[. . . ] Instruction booklet WASHER DRYER Contents GB English GB Installation, 2-3 Unpacking Remove the transit fixings Levelling Water connections Drainage and electrical connections Technical Details Washer dryer description, 4-5 Control panel LEDs Starting and programmes, 6-9 Briefly: starting a programme Programme table Setting the temperature Setting the spin speeds Options Drying section AMXXL 129 Detergents and laundry, Detergent dispenser Preparing your laundry Special items 10 Precautions and advice, 11 General safety Disposal Saving energy and respecting the environment Care and Maintenance, 12 Switching off the water or electricity supply Cleaning Caring for your appliance door and drum Checking the water inlet hoses Troubleshooting, 13-14 Service, 15 Before calling for assistance Spare parts Tr7738gb_AMXXL129. Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the machine to inform the new owner as to its operation and features. Read these instructions carefully: they contain vital information on installation, use and safety. [. . . ] 19 A typical wash and dry programme: 1. Sort your laundry into groups with the same wash and dry care labels. Load the machine, making sure that items are not trapped in the door. Close the door by pushing it until it clicks. Switch the machine on by pressing the ON/OFF button. Select any optional wash feature(s) that you may require by pressing the appropriate button(s). The corresponding LED will illuminate to show what you have chosen. Select a drying time using the Drying time dial. Press the START/CANCEL button to begin the programme. When the programme has finished the ON-OFF / DOOR LOCK LED will flash to indicate that the appliance door can now be opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the machine off by pressing the ON/OFF button, the ON/OFF / DOOR LOCKED LED will go out. GB Drycare tips Items not suitable for tumble drying: • Garments with the ITCL code. Expand when dry, preventing air flow through the appliance. €¢ Items which have been dry cleaned. A 20 minute ‘cool tumble’ is included at the end of drying, allowing fabrics to cool down, minimising creasing. A spin cycle may be carried out during drying if you have set a cotton programme. The sensor dry function can be used on either the cotton (HIGH heat) or synthetic (LOW heat) programmes. Do not put any items into the drawer, other than detergents designed to be released from the drawer, as they may cause damage or blockage. A programme at 60°C instead of 90°C or one at 40°C instead of 60°C will save up to 50% on energy. €¢ Use the correct quantity of detergent, depending on the water hardness, how soiled the garments are and the amount of laundry you have, to avoid wastage and to protect the environment: despite being biodegradable, detergents do contain ingredients that alter the natural balance of the environment. In addition, avoid using fabric softener as much as possible. [. . . ] €¢ Did you select the correct heat/time setting?€¢ Was the laundry spun dry at the end of the wash programme, if not select the spin and dry option to suit the type of fabric?€¢ Is your water pressure within limits?€¢ Call for assistance because this means there is an error. [. . . ]