User manual HOTPOINT AQ9D 682 U H

[. . . ] Instructions for installation and use Contents EN English, 1 WASHING MACHINE EN Installation, 2-3 I Italiano, 13 NL Nederlands, 25 Unpacking and levelling Connecting the electricity and water supplies Technical data Description of the machine, 4-5 Touch control panel FR Français, 37 Running a wash cycle, 6 Wash cycles and options, 7 Table of wash cycles Wash options Detergents and laundry, 8 AQUALTIS AQ9D 682 U H Detergent Preparing the laundry Washing recommendations Load balancing system Precautions and advice, 9 General safety Disposal Opening the porthole door manually Care and maintenance, 10 Cutting off the water and electricity supplies Cleaning the machine Cleaning the detergent dispenser drawer Caring for your appliance drum Cleaning the pump Checking the water inlet hose Trouble shooting, 11 Assistance, 12 1 Installation EN !This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it. Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. [. . . ] Speed (°C) (rpm) Detergent and additives DeterFabric gent for Bleach softener wash                                       Max. Load (kg) Cycle duration EN (*) The duration of the wash cycles can be checked on the display. 90°C) 40° 40° 40° 40° 40° 60° 40° 60° 30° 30° 40° 30° - 1600 1600 1600 1600 600 800 800 800 800 1600 1200 0 600 800 1600 1600 0 9 9 9 9 2 4 4 4 4 9 3, 5 2 2 3, 5 9 9 9 The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected. (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 60456: set wash cycle with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle with a temperature of 40°C. Wash options This option offers a highperformance wash due to the greater quantity of water used in the initial phase 1 of the cycle, and due to 2 the increased wash cycle duration, is particularly useful for the removal of stubborn stains. If you desire bleaching, insert the extra tray compartment (3) into compartment 1. When pouring in the bleach, be careful not to exceed the “max” level marked on the central pivot (see figure). To bleach laundry without carrying out a full wash cycle, pour the bleach into the extra compartment 3, select the “Rinse” cycle and activate the “Super Wash” option . It cannot be used in conjunction with , , , , , 3 Super Wash rotate slowly; the “Easy Iron” and START/PAUSE indicator lights will flash. To end the cycle press the START/PAUSE button or the “Easy Iron” button. For the Silk wash cycle, the machine will end the cycle while the laundry is soaking and the “Easy Iron” indicator light will flash. To drain the water so that the laundry may be removed, press the START/PAUSE button or the “Easy Iron” button. It cannot be used in conjunction with , , , , . If you select this option, the wash cycle duration will be reduced by 30%-50%, depending on the selected cycle, thereby guaranteeing simultaneous water and energy saving. Use this cycle for lightly soiled garments. It cannot be used in conjunction with , , , , , , , , . By selecting this option, the wash and spin cycles will be modified in order to reduce the formation of creases. At the end of the cycle the washing machine drum will Easy Iron By selecting this option, the efficiency of the rinse is increased and optimal residual detergent removal is guaranteed. [. . . ] € The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). € The free end of the hose is under water (see “Installation”). € If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the washing machine to fill with water and drain continuously. Special anti-draining valves are available in shops and help to prevent this inconvenience. [. . . ]