User manual HOTPOINT ARXL 129

[. . . ] IMPORTANT A warning of this danger level signifies possible property damage. If the situation is not avoided it can lead to property damage. The directives in this warning are there to avoid property damage. This device is intended exclusively for the non-commercial use of scanning and digitizing film negatives and slides. [. . . ] Observe the following safety information to avoid danger: Packaging material should not be used as a play thing. The device is delivered with the following components as standard: Scanner 1 x Slide magazine 2 x Negative holder Programme CD Cleaning brush Operating instructions NOTICE Check the contents to make sure everything is there and for visible damage. If the contents are not complete or are damaged due to defective packaging or through transportation contact the service hotline (see the section "Service"). The packaging materials are selected from the point of view of their environmental friendliness and disposal technology and are therefore recyclable. the recirculation of packaging into the material circuit saves on raw material and reduces generated waste. Dispose of packaging material that is no longer needed according to the regionally established regulations. NOTICE If possible preserve the device's original packaging during the warranty period so that in the case of a warranty claim you can package the device properly for return. For safe and faultless operation of the device the set-up location must fulfill the following provisions: The device must be placed on a firm, flat and level surface. Do not place the device in a hot, wet or very damp environment or in the vicinity of flammable materials. System prerequisites You will need a computer with a vacant USB port and with the operating system Windows® XP, Windows® Vista or Windows® 7 from the Microsoft® corporation. GB Installation of the ArcSoft MediaImpression 2 programme NOTICE In these operating instructions only the programme sections are described that you will need for scanning your slides and/or film negatives. When the programme is first started after the installation a calibration and data collection process takes place. Make sure that no slide or negative holders are inserted into the device. The first calibration and data collection process can take several minutes. After completion of the calibration the programme window will be displayed. The window "Capture from scanner" will be displayed. Carry out the necessary settings: File format, quality (only with JPG files), memory location, film type, colour depth, scan resolution NOTICE The colour depth is defined as 24 Bit. A scan with 1800 DPI has a resolution of 2520 x 1680 Pixel and a scan with 3600 DPI has a resolution of 5040 x 3360 Pixel. Slide the holder with the negatives and/or slides to be scanned into the slot 3 on the device until it locks into place. the scan motif will be displayed in the preview field . NOTICE A holder that has been inserted into the device cannot be pulled out again, it has to be pushed completely through the device. adjust the holder , if required , until the scan motif is displayed optimally in the preview window. [. . . ] The complete original declaration of conformity can be obtained from the importer. You receive a 3-year warranty for this device as of the purchase date. This device has been manufactured with care and meticulously examined before delivery. Please retain your receipt as proof of purchase. [. . . ]