User manual HOTPOINT AWD 10

[. . . ] The secrets of fabrics How to get better results M safe ARGHERITA M ARGHERITA AWD 10 Instructions for installation and use GB “A” wash performance Assistance, Spare parts and Accessories? Call your nearest Customer Service Centre or dial 0870 607 0805 The first washer-dryer to give a perfect wash at only 40°C Margherita Washer-dryer and easy to use Margherita - Iinstructions for installation and use M ARGHERITA Quick guide to Margherita Here are the 13 topics explained in this manual. Read, learn and have fun: you will discover many secret ways to get a better wash, more easily and making your washer-dryer last longer. . . . . . and especially keeping an eye on safety. 1. Installation and removal (p. 11) Installation, after delivery or transport, is the most important operation for the correct functioning of your Margherita washer-dryer. That the electric system complies with the law; 2. [. . . ] In most cases, the problems arising can be easily solved without having to call for a technician. Before calling for assistance, always check these points. Is the plug correctly inserted into the socket?It could have been moved whilst cleaning. A circuit breaker could have gone off, perhaps because too many appliances are on at the same time. Or perhaps because of a general power failure in your entire area. Is the washer-dryer door closed properly?For safety reasons, the washerdryer cannot work if the door is open or not shut properly. If it is, then a programmed start has been set. Is the programmed start knob, on those models concerned, in the correct position?For safety reasons, if the washerdryer does not load water, it cannot start a wash cycle. Before calling, read the following But where did all the water go? Troubleshooting Simple: with the new Ariston technology, you need less than half of it, to get good results on twice as much!This is why you cannot see the water through the door: because there is little, very little of it, to respect the environment yet without renouncing maximum cleanliness. And, on top of that, you are also saving electricity. The programme selector knob keeps turning?Wait a few minutes for the drain pump to empty the tub, switch Margherita off, select one of the symbols stop/reset , then switch it back on. If the knob continues to turn, call for assistance because it is reporting an anomaly. The washer-dryer fails to load water. RIGHT Close the tap after every wash cycle. Limit the use of the washer-dryer’s hydraulic system and eliminate leakage risks when no-one is at home. Always leave the appliance door ajar to avoid bad odours. Clean the appliance’s exteriors delicately. To clean the exteriors and the rubber parts of the appliance, always use a rag dipped in lukewarm water and soap. WRONG Leave the washerdryer plugged in while cleaning. Even during maintenance, the appliance should always be unplugged. Never use solvents or abrasives to clean the external and rubber parts of the washerdryer. It is removable and can easily be cleaned by leaving it under running water. [. . . ] Never force the washerdryer door because this could damage the safety block on the opening, which serves to protect from accidental openings. In case of malfunctioning, first close the water tap and unplug the appliance from the wall socket; do not under any circumstances touch internal parts in order to attempt repairs. I only want an authorised specialised technician with original Ariston spare parts! How to change the power supply cable (For this operation we suggest you contact a qualified engineer) The Margherita power supply cable is special and can be purchased exclusively from authorised Tech-nical Service Centres. Make sure that Margherita is switched off and unplugged. Remove the covering lid by unscrewing the two screws I, and then pull it towards you [fig. [. . . ]