User manual HOTPOINT BCB 333 A VE I

[. . . ] 12 12 Operating Instructions REFRIGERATOR/FREEZER COMBINATION Contents I Italiano, 1 GB GB English, 13 F Français, 25 Installation, 14 Positioning and connection Description of the appliance, 15-16 Overall view Control panel DE Deutsch, 37 CZ Èesky, 49 Start-up and use, 17-18-19-20 Starting the appliance Using the display Using the refrigerator to its full potential Using the freezer to its full potential Maintenance and care, 21 BCB 333 A VE I BCB 333 AA VE I BCB 333 AA VE I S Switching the appliance off Cleaning the appliance Avoiding mould and unpleasant odours Defrosting the appliance Replacing the light bulb Precautions and tips, 22 General safety Disposal Respecting and conserving the environment Troubleshooting, 23 Assistance, 24 Installation GB !Before placing your new freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. [. . . ] The trays are drip-free and sealed to prevent food from tainting the ice cubes. Check that the tray is completely empty and fill it with water through the opening provided. Take care not to exceed the level indicated (MAX WATER LEVEL). Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). Close the opening with the lid provided and put the tray back, placing the top part in the corresponding housing and allowing it to drop in again. When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. ICE PARTY: tensures bottles of sparkling wine or champagne reach the right temperature. Place the bottle in the prefrozen ice bucket located inside the FREEZER and STORAGE compartment and select the function on the display. Remove the bottle when the alert is given. The bucket may be used to serve the bottle, keeping it cool after it has been removed from the appliance. MAX WATER LEVEL MAX WATER LEVEL 20 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. set the FREEZER OPERATION and APPLIANCE ON/ OFF Knob on Off 2. If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. To restore normal operation, it is sufficient to set the FREEZER OPERATION and APPLIANCE ON/OFF knob on the desired value. To disconnect the appliance, follow point 1 and 2. Defrosting the freezer compartment Remove frost regularly using the special scraper provided. If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. One day before enabling the SUPER FREEZE function in the 24-hour mode; it helps give the food a healthy extra "cold shock". After 24 hours, the freezing function is automatically disabled but you can disable it yourself. Turn the appliance off by turning the FREEZER OPERATION and APPLIANCE ON/OFF knob. [. . . ] € The food is in contact with the back inside wall of the refrigerator. € The outside ambient temperature is very high. € The internal refrigerant makes a slight noise even when the compressor is off. • The water discharge hole is blocked (see Maintenance). [. . . ]