User manual HOTPOINT BF 101/B/HA

[. . . ] • The voltage is in the range of values indicated on the data plate located inside the freezer (e. • The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it (see Assistance). Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. [. . . ] • In order to freeze fresh foods, the switch must be turned to the left (the YELLOW idicator light will come on). Then introduce the food to be frozen into the top compartment, placing them - to the furthest extent possible - in direct contact with the cooling plate and away from any frozen food being stored. After 24 hours have passed and the food has been frozen, turn the freezer switch back to the normal setting (the YELLOW light will turn off). Remember to carry out this last step in order. • Placing large amounts of fresh food in the freezer may temporarily increase the temperature inside the appliance (this is indicated when the RED indicator light illuminates). This situation, as it is only temporary, does not adversely affect the storage conditions of food that is already frozen. 12 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. Turn off the GREEN indicator light (move the switch-2 to the left); 2. Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. The day before defrosting, turn on the YELLOW indicator light (move the switch-1 to the left) to further cool the food. Wrap frozen foods in newspaper and place them in another freezer or in a cool place. Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment. Certain appliances are fitted with the DEFROST WATER DRAIN system. Let the water flow into a container (see diagram). GB Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Clean and dry the freezer compartment carefully before switching the appliance on again. Until the ideal storage conditions have been restored, before placing food in the freezer compartment. [. . . ] • Defrost the appliance if ice forms (see Maintenance). A thick layer of ice makes cold transference to food products more difficult and results in increased energy consumption. • Regularly check the door seals and wipe clean to ensure they are free of debris and to prevent cold air from escaping (see Maintenance). 14 Troubleshooting If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list. [. . . ]