User manual HOTPOINT C 647 G A R

[. . . ] 12 Important safety warnings To maintain the EFFICIENCY and SAFETY of this appliance, we recommend: • call only the Service Centers authorized by the manufacturer • always use original Spare Parts 1 These instructions are only for those countries whose symbols appear in the booklet and on the matriculation plate of the appliance. 2 This appliance is intended for non-professional use within the home. 3 This owner's manual is for a class 1 appliance (installed independently) or class 2 - sub-class 1 appliances (installed between two cabinets). 4 Before using the appliance, read the instructions in this owner’s manual carefully since you should find all the instruction you require to ensure safe installation, use and maintenance. [. . . ] E) The wall in contact with the back of the cooker must be of flameproof material. Connecting the gas The appliance should be connected to the mains or to a gas cylinder in compliance with current directives. Before making the connection, check that the cooker is regulated for the gas supply you are using. If not, follow the instructions indicated in the paragraph “Adapting to different types of gas”. On some models the gas supply can be connected on the left or on the right, as necessary; to change the connection, reverse the position of the hose holder with that of the cap and replace replace the gasket (supplied with the appliance). When using liquid gas from a cylinder, install a pressure regulator which complies with current directive. Important: check that the supply pressure complies with the values indicated in table 1 “Characteristics of the burners and nozzles” since this will ensure safe operation, correct consumption and ensure a longer life to your appliance. Connection with hose Make the connection using a gas hose complying with the the characteristics provided in current directive. B); • remove the screw and then the oven burner “V”(see Fig. Remove the oven door to facilitate this operation. € unscrew the oven burner nozzle using the special socket spanner for the nozzles (see Fig. D), or better still a 7 mm socket spanner, and replace it with a nozzle suited to the new type of gas (see table 1). € check that the burner does not turn off when you turn the knob from Max to Min and and when you open and close the oven door quickly. Adapting the gas grill to different types of gas Replacing the nozzle of the grill burner: • remove the screw and then slide out the grill burner “V” (see Fig. E); • unscrew the grill burner nozzle using the special socket spanner for the nozzles (see Fig. F) or better still a 7 mm socket spanner; replace the nozzle with a nozzle for the new type of gas (see table 1). F Important: when mounting the grill burner check that there is a space of at least 4 mm between the security thermocouple (if installed) and the burner. D b) Minimum regulation of the gas oven burner with thermostat (see fig. ): • light the burner as described in the paragraph “the oven knob” of the instruction booklet. € turn the knob to Max for about 10 minutes and then turn the knob to the Min setting; • remove the knob; • regulate the screw positioned outside the thermostat pin until the flame is small but steady. : in the case of liquid gas, the regulation screw must be screwed in to the bottom. 4 mm Important On completion of the operation, replace the old rating sticker with one indicating the new type of gas used. [. . . ] Cooked well on the inside but sticky on the outside Use less liquid, lower the temperature, and increase the cooking time. The pastry sticks to the pan Grease the pan well and sprinkle it with a dusting of flour. I used more than one level and they are not all at the same cooking point Use a lower temperature setting. It is not necessary to remove the food from all the racks at the same time. [. . . ]