User manual HOTPOINT CE6IFA.T X F /HA

[. . . ] THERMOSTAATKNOP 3 3 13 14 1 9 15 10 6 5 Booster Booster Booster 7 12 4 2 8 11 GB Description of the appliance Control panel FR Description de l’appareil Tableau de bord The control panel described in this manual is only a representative example: it may not exactly match the panelon your appliance. 1 INCREASE POWER button switches on the hotplate and controls the power (see Start-up and use). 2 REDUCE POWER button controls the power and switches off the hotplate (see Start-up and use). 3 COOKING ZONE SELECTOR indicator shows a particular cooking zone has been selected and therefore various adjustments are possible. [. . . ] This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. The booster stops automatically after 4 minutes. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. Booster Switching off the cooking zones To switch off a cooking zone, select it using the corresponding selector button • Press the button: the power of the cooking zone will progressively decrease until it is switched off. - and: - + Programming the cooking duration !All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. Adjust the power level of the cooking zone. Press the light corresponding to the selected zone will start flashing. Set the cooking duration using the - + and Control panel lock buttons. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press button to lock the control panel: the indicator the light above the button will switch on. To stop cooking), you button for a must switch off this function. Press the few moments, the indicator light will switch off and the lock function will be removed. Confirm by pressing the selection occurs after 10 seconds. The timer begins counting down immediately. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. [. . . ] To obtain the best results from the pyrolysis cycle, we recommend that you do not use the hob while the process is being carried out. To activate the FAST CLEAN cycle press and hold the button for approximately 4 seconds. The TIMER KNOB may be used to select the desired cleaning level; there are three default time settings which cannot be modified. Economy (ECO): turn the knob towards “-”. [. . . ]