User manual HOTPOINT CG64SG1

[. . . ] 12 Operating Instructions COOKER GB IT Italiano, 1 GB English, 13 ES Espanol, 24 Contents Positioning and levelling Electrical connection Gas connection Adapting to different types of gas Technical data Table of burner and nozzle specifications Installation, 14-17 PT Portuges, 35 GR ÅëëçíéêÜ, 46 Description of the appliance, 18 Overall view Control panel Start-up and use, 19-21 CG64SG1 I /HA CG64SG1 X I /HA CG64SG1 AG /HA CG64SG1 X AG /HA Using the hob Using the oven Oven cooking advice table Precautions and tips, 22 General safety Disposal Respecting and conserving the environment Care and maintenance, 23 Switching the appliance off Cleaning the appliance Replacing the oven light bulb Gas tap maintenance Assistance Installation GB  Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance.  Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved. [. . . ] 16  If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. TECHNICAL DATA Oven Dimensions HxWxD Volume Useful measurements relating to the oven compartment Voltage and frequency 31x43, 5x43, 5 cm 58 l width 46 cm depth 42 cm height 8, 5 cm see data plate may be adapted for use with any type of gas shown on the data plate. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished.  Be careful of the spark plug wires and the thermocouple tubes.  After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one that corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres).  Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to “regulators for channelled gas”. 00 Nominal (mbar) Supply Minimal (mbar) pressure Maximised (mbar) * At 15°C and 1013 mbar - dry gas ** Propane P. 78 MJ/m³ Diameter (mm) By Pass 1/100 (mm) 41 30 30 52 S S R A CG64SG1 CG64SG1 CG64SG1 CG64SG1 I /HA X I /HA AG /HA X AG /HA 17 Description of the appliance GB Overall view Glass cover* Gas burner Hob grid Control panel Containment surface for spills GUIDE RAILS for the sliding racks position 5 position 4 position 3 position 2 position 1 Adjustable foot GRILL rack DRIPPING PAN Adjustable foot Control panel GRILL indicator light OVEN LIGHT button GAS BURNER ignition button* HOB BURNER control knobs OVEN control knob TIMER knob* * Only available in certain models. 18 Start-up and use Using the hob Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting -.  Never put objects directly on the bottom of the oven; this will avoid the enamel coating being damaged. Only use position 1 in the oven when cooking with the rotisserie spit. Lighting the oven To light the oven burner, bring a flame or gas lighter close to opening F (see figure) and press the OVEN control knob while turning it in an anticlockwise direction until it reaches the MAX position. , then hold the F If the appliance is fitted with an electronic lighting device* (see figure), press the ignition button, marked with the symbol control knob and turn it in an anticlockwise direction, towards the MAX position, until the burner is lit. If, after 15 seconds, the burner is still not alight, release the knob, open the oven door and wait for at least 1 minute before trying to light it again. If there is no electricity the burner may be lit using a flame or a lighter, as described above. , then hold the OVEN * Only available in certain models. 19 GB  The oven is fitted with a safety device and it is therefore necessary to hold the OVEN control knob down for approximately 6 seconds.  If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight the oven. Adjusting the temperature To set the desired cooking temperature, turn the OVEN control knob in an anticlockwise direction. [. . . ] We recommend that the oven is not used until the seals have been replaced. GB Cleaning the appliance  Never use steam cleaners or pressure cleaners on the appliance. • The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. [. . . ]