User manual HOTPOINT CG65SG1 X UA /HA

[. . . ] Audio input from an external A/V device can be brought into the WinTV via the white and red audio input jacks. If you would like to use FM radio, plug the supplied Radio aerial into the FM radio connector. This may not be necessary if your TV aerial supplies FM, or if you do not want to listen to radio with Media Center. [. . . ] Start your computer and wait for Windows Vista to fully boot. pIug the supplied Power Supply into the Power Supply input on WinTVPVR-USB2. Cancel any 'Found new hardware wizards' you may see. Insert your WinTV Installation CD-ROM and click on Start then 'Computer', you should then see the HCW CD under 'Devices with removeable media', double click on this CD-ROM then double click on the file called 'HCWDriverInstall'. You will then be presented with a blue screen which will begin installing and updating the drivers for your product. The WinTV-PVR-USB2 device, with analogue TV tuner, FM radio and hardware MPEG encoder The Wall mounted power supply 6V/1. 5A Media Center Remote control transmitter and two AA batteries Media Center remote control receiver box for USB IR transmitter cable WinTV-PVR MC Driver Installation CD-ROM WinTV for Media Center Quick Installation Guide (this guide) You won't need them to use Microsoft Media Center application. increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. consult the dealer or an experienced radio/TV technician for help. FCC ID: H90WINTV CAUTION: Changes or modifications not expressly approved by the party responsible for compliance to the FCC Rules could void the user's authority to operate the equipment. If you have a satellite set top box and would like the Media Center remote control receiver/blaster to change channels on the set top box, plug one end of the IR transmitter cable into the back of the Media Center remote control receiver/blaster and position the other end (the transmitter end) over the IR receiver on your set top box. On the main menu scroll down until you reach the Tasks menu, once there scroll left until you reach Settings, press OK on your remote to activate this menu. From here scroll down and select 'TV' then 'Setup TV Signal'. [. . . ] On the main menu scroll down until you reach the Tasks menu, once there scroll left until you reach Settings, press OK on your remote to activate this menu. From here scroll down and select 'TV' then 'Setup TV Signal'. You will then be guided through a wizard to set up the type of signal you wish Media Center to receive. [. . . ]