User manual HOTPOINT CM HM QBB0

[. . . ] 13 en SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED • Before using the appliance carefully read the Health and Safety, and Use/Care guides. €¢ Keep these instructions close at hand for future reference. €¢ YOUR SAFETY IMPORTANT AND SAFETY OF OTHERS IS VERY • This manual and the appliance itself provide important safety warnings, to be read and observed at all times • All safety warnings give specific details of the potential risk presented and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions. [. . . ] €¢ Wash the tank using a hard brush, water and washing-up liquid, then clean it thoroughly, dry it and put it back to place. Capsule loading lever Short and long coffee buttons Used-capsules container Drip grid Espresso cup support Drip drawer Coffee maker main body Removable water tank Water tank lid Milk frother supply base Milk frother buttons Milk frother handle Milk frother jug Milk frother lid Short long coffee button (fig. J) that the tank is securely fastened in order to prevent water spill. Switch on the coffee maker pressing the ON/OFF button on the back. The product turns on and the buttons flash together during the heating up of the machine. When the correct temperature is reached, the buttons light stops blinking. Place a cup or a glass under the supplying spout. With the appliance heated up, and without inserting any capsule, press the short coffee button (PICTURE B) and supply water for 10 seconds, then press the button again to stop. In case the coffee maker does not supply water, remove and plug the water tan checking the correct positioning. Repeat the operation untill the machine dispenses water. Use this procedure also in case the appliance has not been used for long time. PREPARING THE COFFEE INTRODUCTION Thank you for purchasing our product. In doing so, you have opted for an effective highperformance appliance. If the instructions on the correct use of this appliance are not observed, the manufacturer shall assume no responsibility for any resulting damage. The operating instructions may refer to different models: any difference is clearly identified. USING YOUR COFFEE MAKER PREPARING THE COFFEE MAKER Before you assemble the coffee maker, ensure that the power cord is unplugged and take care that the main body and all other parts are clean. Fit the power cord on the cable rack on the bottom of the machine based on its distance from the outlet (PICTURE A). In case it is not easy to take out, turn it slightly outwards. Fill the tank with water until maximum level. Reinstall the tank by leaning it in place and press the top part until the complete joint. Check the water level inside the water tank. Make sure the water is greater than minimum level and enough to brew the coffee. [. . . ] MAINTENANCE AND CLEANING • • • • • • • PREPARING THE BEVERAGE We recommend using milk with a high fat content. For best results, take the milk out of the refrigerator immediately before using it. The bottom of the jug and the milk frother supply base must be clean and dry. PRELIMINAY INFRMATIONS • Use the whisky with metallic wire (19, PICTURE J) for frothed preparation, bth cold and hot. [. . . ]