User manual HOTPOINT E2BGH 19223 F

[. . . ] This appliance is designed for domestic use or similar applications, for example: - staff kitchen areas in shops, offices and other work environments; - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. Disposal • Disposal of packaging material: observe local legislation so that the packaging may be reused. € The European Directive 2012/19/EU relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the re-using and recycling rate of the materials inside the machine, while preventing potential damage to the environment and public health. [. . . ] At the end a few beeps * will signal the end of the wash cycle and the END indicator light will go on. Switch off the appliance by pressing the ON/OFF button, shut off the water tap and unplug the appliance from the electricity socket. Wait a few minutes before removing the crockery to avoid getting burnt. Unload the racks, beginning with the lower level. - The machine will switch off automatically during certain periods of inactivity in order to minimise electricity consumption. Changing a wash cycle in progress If a mistake was made in the wash cycle selection process, it is possible to change the cycle provided that it has only just begun: once the wash cycle has started, in order to change the wash cycle switch off the machine by pressing and holding the ON/OFF/Reset button. Switch it back on using the same button and select the desired wash cycle and options. Introduce the detergent into the dry dispenser “B” only. Place the amount of detergent for pre-washing directly inside the tub. When measuring out the detergent refer to the Table of wash cycles to add the proper quantity. Compartment B comprises a level showing the maximum quantity of liquid or powder detergent that can be added to each cycle. To reduce consumption even further, only run the dishwasher when it is full. Standby consumption: Left-on mode consumption: 5 W – Off mode consumption: 0, 5 W Consumption data table for the main cycles Standard conditions* Energy consumption (kWh/cycle) INTENSIVE NORMAL Water consumption (l/cycle) Duration (min/cycle) User conditions** Energy consumption (kWh/cycle) Water consumption (l/cycle) Duration (min/cycle) 1, 50 1, 20 15 15 150 120 1, 30 1, 05 14 14 135 110 * Cycle data refers to the values recorded in a laboratory, in accordance with European standard EN 50242. ** Data is obtained by recording values when the appliance is operational and loaded with user crockery. 22 Special wash cycles and Options Notes: Optimum performance levels when using the “Fast" and "Express 40’” cycles can be achieved by respecting the specified number of place settings. * The Eco wash cycle complies with regulation EN-50242. Although it has a longer duration than other wash cycles, it uses less energy and is less harmful to the environment. Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address: ASSISTENZA_EN_LVS@indesitcompany. Com If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent. Select the wash cycle and press the HALF LOAD button; the indicator light will go on. Press the HALF LOAD button again to deselect this option. half load* EN Remember to halve the amount of detergent. [. . . ] • The appliance has not been plugged in properly. € The dishwasher door has not been shut properly. Strongly push the door until a “clacking” noise is T heard. The dishes and glasses are covered in a white film or limescale deposits. [. . . ]