User manual HOTPOINT FB G IX

[. . . ] 12 Congratulations on choosing an Ariston appliance, which you will find is dependable and easy to use. We recommend that you read the instructions in this owner’s manual carefully before use for the best performance and to extend the life of your appliance, as it will provide you with all the instructions you require to ensure its safe installation, use and maintenance. Always keep this owner’s manual close to hand since you may need to refer to it in the future. Guides for sliding the racks or dripping pan in and out How to use your oven The various features of this oven are controlled via the knobs and buttons located on the control panel. [. . . ] Important: Check that the supply pressure complies with the values indicated in table 1 “Burner and Nozzle Characteristics” since this will ensure safe operation, correct consumption and ensure a longer life to your appliance. Should you need to install a gas hob on top of a builtin gas oven, it is strictly forbidden to make the connection between the two or to use a single cut-off tap. The two appliances should be connected separately, and each one should have its own stop tap to render them independent from one another. v · Unscrew the oven burner nozzle using the special socket spanner for the nozzles, or a 7 mm socket spanner, and replace it with a nozzle suited to the new type of gas (see Table 1). Take particular care handling the spark plug wires and the thermocouple pipes. Replace all the parts, following the steps described above in the reverse order. NO OK Connection with a rigid pipe (copper or steel) Connection to the gas system must be made in such a way as not to cause any stress of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the supply ramp to the appliance, whose watertightness is ensured by a seal. Should you need to turn the pipe fitting, you must in all cases replace the seal (provided with the appliance). Only use pipes and seals that comply with the current National Norms. These pipes must be installed so that their length is never any longer than 2000 mm when fully extended. Once the connection has been made, ensure that the flexible metal pipe does not touch any moving parts and is not crushed. Checking that the connection is tight When installation is complete, check the pipe fittings for leaks using a soapy solution. Adapting to different types of gas In order to adapt the oven to a different type of gas with respect to the gas for which it was manufactured (indicated on the label), follow these simple steps: a) Replacing the oven burner nozzle · open the oven door fully · Pull out the sliding oven bottom · unscrew the burner fastening screws · Remove screw “V” and then the oven burner; 21 Regulating the Primary Air for the Oven Burner b) the burner was designed not to need any adjustments to the primary air. Minimum regulation of the oven burner c) Regulate the oven burner minimum: · Turn the knob first to the Max setting for about 10 minutes and then to Min; · remove the knob · Remove the disk fastened to the control panel · Adjust the screw located outside the thermostat cock pin until the flame is small but steady (the flame can be seen through the slots on the oven bottom). : In the case of liquid gas, the regulation screw must be screwed in all the way. Check that the burner does not turn off when you turn the knob from Max to Min quickly and when you open and close the oven door quickly. Warning On completion of this operation, replace the old rating sticker with one indicating the new type of gas used. This sticker is available from our Service Centres. Note Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to fit a suitable pressure regulator onto the inlet pipe (in compliance with the current National Norms regarding “regulators for channelled gas”). 5 cm Depth 43 cm Height 31 cm Inner Volume of the Oven: 58 litres This appliance conforms with the following European Economic Community directives: 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications; 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications; 90/336/EEC of 29/06/90 (Gas) and subsequent modifications; 93/68/EEC of 22/07/93 and subsequent modifications. 2002/96/EC The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. [. . . ] Should you need to install a gas hob on top of a builtin gas oven, it is strictly forbidden to make the connection between the two or to use a single cut-off tap. The two appliances should be connected separately, and each one should have its own stop tap to render them independent from one another. N L Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. When connecting the cable directly to the mains, install an omnipolar circuit-breaker with a minimum contact opening of 3 mm between the appliance and the mains. [. . . ]