User manual HOTPOINT FDD10761XR

[. . . ] This symbol reminds you to read this instruction manual. GB GB English, 1 HU IT Italiano, 13 TR Türkçe, 25 Contents Installation, 2-3 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data FR Français, 37 GR ΕΛΛΗΝΙΚΑ, 49 CZ Česky, 61 Care and maintenance, 4 Cutting off the water or electricity supply Cleaning the washer-dryer Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose SK Slovensky, 73 Precautions and tips, 5 FDD 10761 General safety Disposal Opening the porthole door manually Description of the washer-dryer, 6-7 Control panel Display How to run a wash cycle or a drying cycle, 8 Wash cycles and functions, 9 Table of wash cycles Wash functions Detergents and laundry, 10 Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system Troubleshooting, 11 Service, 12 1 Installation GB !This instruction manual should be kept in a safe place for future reference. If the washerdryer is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features. [. . . ] Open the detergent dispenser drawer and pour the detergent into the relevant compartments as described in “Detergents and laundry”. Press one of the WASH CYCLE SELECTOR buttons to select the required wash cycle; the name of the wash cycle will appear on the display. A temperature and spin speed is set for each wash cycle; these may be adjusted. The duration of the cycle will appear on the display. Use the relevant buttons: Modifying the temperature. The machine automatically select the maximum temperature set for the selected wash cycle; this values cannot therefore be increased. The temperature can be decreased by pressing the button, until the cold wash “OFF” setting is reached. If this button is pressed again, the maximum values are restored. Exception: if the 2 (60°) (1st press of the button) programme is selected, the temperature can be increased up to a value of 90°C. To set a delayed start for the selected programme, press the corresponding button repeatedly until the required delay period has been reached. When this option is enabled, the symbol lights up on the display. To remove the delayed start function press the button until the text “OFF” appears on the display. The desired drying cycle type may be set by pressing the DRYING button once or several times. Two options are available: A - Based on the how damp the clothes are once they have been dried: Iron: suitable for clothes which will need ironing afterwards. The remaining dampness softens creases, making them easier to remove. Hanger: ideal for clothes which do not need to be dried fully. Cupboard: suitable for laundry which can be put back in a cupboard without being ironed. Extra: suitable for garments which need to be dried completely, such as sponges and bathrobes. B - Based on a set time period: between 20 and 180 minutes. To exclude the drying phase press the relevant button until the text OFF appears on the display. If your laundry load to be washed and dried is much greater than the maximum stated load, perform the wash cycle, and when the cycle is complete, divide the garments into groups and put some of them back in the drum. At this point, follow the instructions provided for a “Drying only” cycle. [. . . ] • The START/PAUSE button has not been pressed. € The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”). € The free end of the hose is under water (see “Installation”). € The wall drainage system is not fitted with a breather pipe. [. . . ]