User manual HOTPOINT FZ 102 P.1 IX/HA

[. . . ] 13 Operating Instructions OVEN Contents IT Italiano, 1 GB English, 14 FR Français, 27 Installation, 15-16 Positioning Electrical connection Data plate Overall view Control panel GB E S Espanol, 40 P T Português, 53 Description of the appliance, 17 Start-up and use, 18 Control panel lock DEMO mode Setting the clock and timer Starting the oven Cooking modes, 19-22 FZ FZ FZ FZ FZ FZ FZ FZ 102 P. 1 IX F/HA Manual cooking modes Automatic cooking modes Programming the cooking mode Practical cooking advice Cooking advice table Precautions and tips, 23 General safety Disposal Respecting and conserving the environment Care and maintenance, 24-25 Switching the appliance off Cleaning the appliance Cleaning the oven door Replacing the light bulb Assembling the sliding rack kit Automatic cleaning with the FAST CLEAN function Assistance, 26 Installation  Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance.  Please keep these operating instructions for future reference. [. . . ] Please see the following chapter for further details. • Cut the dough into equal sized loaves. • Place them in the dripping pan on oven paper. • Remember to pour 100 ml of cold water into the baking tray in position 5. For cleaning purposes, we recommend the use of water and vinegar. • Place the loaves inside the oven while it is still cold. • Once baked, leave the loaves on one of the grill racks until they have cooled completely. 20 Programming cooking  A cooking mode must be selected before programming can take place. Programming the duration button, then: Press the 1. Adjust the time using the “+” and “-” buttons on the left hand side of the control panel. Press the button to memorise the setting. Press the “START” button to confirm the programming process. When the set time has elapsed, END appears on the TEMPERATURE display and a buzzer sounds. And a time of 1 hour and 15 minutes is programmed. Press the button and repeat steps 1 and 2 as described. Then press the button and set the end time using the “+” and “-” buttons on the left hand side of the control panel. Press the button to memorise the setting. Press the “START” button to confirm the programming process. When the selected time has elapsed, END appears on the TEMPERATURE display and a buzzer sounds. And a time of 1 hour and 15 minutes is programmed and the end time is set to 12:30. The TIME and DURATION displays show the end time and the duration alternately. to cancel a programming procedure press the “STOP” button. [. . . ] Once the automatic cleaning cycle is over You will have to wait until the temperature inside the oven has cooled down sufficiently before you can open the oven door. You will notice some white dust deposits on the bottom and the sides of your oven; remove these deposits with a damp sponge once the oven has cooled down completely. Alternatively, you can make use of the already heated oven, in which case it is not necessary to remove the deposits, they are completely harmless and will not affect your food in any way. Finally, fit the frames on the spacers A. [. . . ]