User manual HOTPOINT H6V5D60

[. . . ] Do not close the glass cover (if present) when the gas burners or electric hotplates are still hot. WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. When you place the rack inside, make sure that the stop is directed upwards and in the back of the cavity. 8 We recommend cleaning the oven before using it for the first time, following the instructions provided in the "Care and maintenance" section. [. . . ] If, for example, you want cooking to end at 13. 4 seconds after the buttons are released, the current time (for example 10. 00) reappears on the display with the letter A (AUTO). At this point, the oven is programmed to switch on automatically at 12:30 and switch off after 30 minutes, at 13. Setting the cooking time with an immediate start Follow the above procedure for setting the cooking time (points 1-3). When the letter A appears, this indicates that both the cooking time and the end cooking time have been programmed in AUTO mode. To restore the oven to manual operation, after each AUTO cooking mode press and END COOKING TIME the COOKING TIME buttons simultaneously. Will remain lit, along with the oven, for !The symbol the entire duration of the cooking programme. The set cooking duration can be displayed at any time , and the by pressing the COOKING TIME button cooking end time may be displayed by pressing the END COOKING TIME button . When the cooking time has elapsed a buzzer sounds. To switch it off again, turn the knob in an anticlockwise direction until it is in the “0” position. If the COOKING ZONE ON indicator light is lit, this shows that at least one pf the cooking zones on the hob is switched on. traditional cooking zone control knobs. Each cooking zone is fitted with a control knob allowing you to select from 12 different temperature settings from a minimum of 1 to a maximum of 12. cooking zones The hob is equipped with electric radiant heating elements. When they are in use the following items on the hob become red. The cooking zone B with radiant heating elements. The cooking zone with HILITE heating elements. The residual heat indicator light: this indicates C . That the temperature of the corresponding cooking zone is greater than 60°C, even when the heating element has been switched off but is still hot. cooking zones with radiant heating elements. [. . . ] Press the two buttons on the upper profile and extract the profile (see photo) The Diamond Clean mode is an automatic cleaning cycle which releases steam inside the cavity and uses the exclusive Diamond Clean enamel to make it easy to remove any dirt residues from the cavity and accessories. Available in three different levels: Economy, Normal and Intensive - to be used based on the type of dirt. The Diamond Clean cycle can be used to keep the oven always clean. During the cleaning process steam is released inside the cavity which, together with the titanium-based Diamond Clean enamel (on the inside walls of the oven and dripping pans), makes it easy to clean the oven. [. . . ]