User manual HOTPOINT HDA 9 T/HA

[. . . ] DE 23 Instruction on mounting and use Cooker hood Contents IT Italiano EN DE Deutsch EN English Installation, 26 Installation, 26 Description of the appliance, 31 Control panel, 31 FR Français NL Nederlands ES Español Operation, 32 Maintenance, 33 Cleaning, 33 Cleaning the grease filters, 33 Cleaning the carbon filter, 33 Mounting and changing the filter, 33 Replacing lamps, 34 PT Português Caution, 35 HDAI HDSI HFI HDA HDS HF HFD General safety, 35 Disposal, 35 25 Installation EN !It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or move, make sure it is together with the product. Read the instructions carefully: there is important information about installation, use and safety. [. . . ] Couple the two lower sections of the flue to cover the trellis using 6 screws (3 per side - also see the plan diagram for coupling the two sections). Insert the lower section of the flue into the apposite housing to cover the motor space and the electrical connection box completely and fix with two screws from inside the hood. Apply the 2 tabs (supplied) to cover the fixing points of the sections of the lower flue (ATTENTION! tHE TABS FOR THE LOWER FLUE ARE RECOGNISABLE BECAUSE THEY ARE NARROWER AND LESS DEEP). The larger and deeper tabs are those to use for the upper flue and are to be cut to measure. Supply the electrical power again acting on the central electrical panel and check the correct functioning of the hood. 28 Installation wall model When the vapour catcher is disassembled, it must be fixed as shown in Fig. The electric connection box must be assembled as shown in Fig. Drawing a line on the wall with a pencil up to the ceiling, corresponding to the centre line, will make the installation operations easier. Apply the perforation diagram to the wall: the vertical centre line printed on the perforation diagram should correspond to the centre line drawn on the wall. In addition, the lower edge of the perforation diagram corresponds to the lower edge of the hood. Make holes as indicated on the template, insert the wall dowels and screw 2 screws into the upper holes, leaving a space of about 1 cm between the head of the screw and the wall. Note: Always make the holes indicated on the template. The upper 2 are for hooking the hood up while the lower holes (generally 1 central or more lateral) are for the definitive and safety fixing. Apply flues support bracket „G“ to the wall touching the ceiling. Use the flues support bracket as a perforation diagram (the small slot in the support must coincide with the line previously drawn on the wall, if present), and mark two holes with a pencil. Fix the flues support bracket to the wall with 2 screws. Hang the hood to the two upper screws (see installation phase 3). Introduce and screw the screws (and washer(s)) up into the hole(s) for the definitive fixing (COMPULSORY!Then, having checked the setting of the hood, TIGHTEN ALL THE upper and lower SCREWS. Note: the lower fixing points are visible removing the fats filters and they are at the sides and/or at the centre of the hood (after having removed the frame of the carbon filter, if present, in the latter case). In any case, we recommend using the lateral holes, when available, to increase the stability of the hood. [. . . ] Clean using the cloth dampened with neutral liquid detergent. WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. Therefore, we recommend oserving these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. [. . . ]