User manual HOTPOINT HGA 6.8 AB X/HA

[. . . ] If the installation instruction manual for the gas cooking appliance specifies a greater distance, this measurement should be taken into account. € The cooker hood comes with anchor plugs which are suitable for use with most walls/ceilings. However, you must contact a qualified technician to check the suitability of the materials in relation to the type of wall/ ceiling, which must be strong enough to support the weight of the unit. Do not hook the unit up to its electrical power supply until the installation has been completed. [. . . ] If the hood has a power plug, connect the hood to an easily accessible regulatory power socket. If it does not (direct connection to the mains), or the socket is not easily accessible, install a two-pole regulatory switch to enable total disconnection from the mains in case of category III overvoltage, as required by the installation regulations. Always check that the mains cable is hooked up properly and check that it operates correctly before reconnecting the hood to the mains. Air exhaust (for ducted units) Connect the hood to a duct and wall exhaust hole of a diameter equal to that of the air outlet flange. Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also increases its running noise. The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Pressing the button while the hood is in operation turns it OFF. T2 Speed Pressing the button returns the hood to the previous speed. B T1 T2 T3 T4 T5 T6 T3 Speed + Pressing the button returns the hood to the next speed. T4 Booster Pressing this button sets the hood to high speed; the letter "b" flashes slowly on the display. After 5 minutes, the hood returns to its previous speed; this can also be done while booster mode is on by pressing either speed button (T2 or T3). T5 Timer Pressing this button delays the hood turning off automatically by 5 minutes. The timer counts down on the display in minutes. The timer can only be set for manual speeds, not for booster mode. T6 Lights ON/OFF T1 Motor reset Press the button with the hood off to set speed 1. Pressing the button while the hood is in operation turns it OFF. T2 Speed 1 Pressing the button sets the hood to speed 1. [. . . ] GB If both bars are flashing, then both filters are saturated. You must then clean/replace the grease filter (A) or odour filter (B) or both, accordingly (see “Maintenance and care”). The latter only applies to the filter version. To reset the filter counter: Hold down T4 for three seconds while the hood is on. [. . . ]