User manual HOTPOINT HGA 9.5 AM X

[. . . ] If the installation instruction manual for the gas cooking appliance specifies a greater distance, this measurement should be taken into account. € The cooker hood comes with anchor plugs which are suitable for use with most walls/ceilings. However, you must contact a qualified technician to check the suitability of the materials in relation to the type of wall/ ceiling, which must be strong enough to support the weight of the unit. Do not hook the unit up to its electrical power supply until the installation has been completed. [. . . ] Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Do not connect the hood to flues carrying combustion fumes from other equipment )boilers, GLASSs, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior )this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. 5SS AB X Bulb (V) Halogen Bulb draw (W) Total draw (W) 2 x 40 185 Model code HGA 9. T5 Timer Pressing this button delays the hood turning off automatically by 5 minutes. The timer counts down on the display in minutes. The timer can only be set for manual speeds, not for booster mode. T6 Lights ON/OFF T1 T2 T3 T4 T5 T6 T1 Motor reset Pressing the button while the hood is in operation turns it OFF. T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. T5 Booster Pressing the button sets the hood to high speed. After 5 minutes, the hood returns to the previous speed; pressing a speed button )T2, T3 or T4) quits booster mode and sets the selected speed. T6 Lights ON/OFF 16 Grease/odour filter warnings The bar at the top left flashes to indicate that the grease filter is saturated. The bar at the top right flashes to indicate that the odour filter is saturated. [. . . ] If both filter warnings are active at the same time, you must reset each separately. The first sequence resets the grease filter, while the second sequence resets the odour filter. Configuring the hood To set the operating mode of the hood, hold down T4 for 6 seconds. After a long beep, the type of installation displays: Ducted (square at bottom left flashing(. [. . . ]