User manual HOTPOINT HGF 6.5 AM X/HA

[. . . ] Or persons with sensory or mental disability and lack of experience or familiarity, except under the supervision or instruction of a person responsible for their safety. In relation to the technical and safety measures to be employed in fumes extraction. And out (AT LEAST ONCE A MONTH, and in observance of the maintenance instruction given in this manual). [. . . ] The manufacturer is not liable for any consequences of failure to observe these instructions. Of exhaust tube (cm) 15/12 15/12 Model code Bulb (V) Halogen Bulb draw (W) Total draw (W) 2 x 40 185 Model code Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 40 290 Model code Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 40 150 Filter or ducted?The hoods are conforming to the following EC Directives: Note: If supplied with the hood, the accessory active Instructions for transforming the hood from the ducted to the 35 GB GLASS controls The T2 saturated, while T3 A) B) or both, accordingly (see “Maintenance T1 T2 T3 T4 T5 Hold down T4 for three seconds while the hood is on. T1 Motor reset Pressing the button while the hood is in operation turns it time, you must reset each separately. T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. T5 Lights ON/OFF 1 Motor ON/OFF Press the button with the hood off to set speed 1. Pressing B T1 T2 T3 T4 T5 T6 T2 Speed Pressing the button returns the hood to the previous speed. B T1 T2 T3 T4 T5 T6 T3 Speed + Pressing the button returns the hood to the next speed. If the hood is off, pressing these buttons sets speed 1. T4 Booster "b T1 Motor reset Pressing the button while the hood is in operation turns it T2 Speed 1 Pressing the button sets the hood to speed 1. T3 Speed 2 Pressing the button sets the hood to speed 2. T4 Speed 3 Pressing the button sets the hood to speed 3. T5 Booster Pressing the button sets the hood to high speed. After 5 a speed button (T2, T3 or T4) quits booster mode and sets the selected speed. t6 Lights ON/OFF booster mode is on by pressing either speed button (T2 or T3). T5 Timer Pressing this button delays the hood turning off automatically by 5 minutes. [. . . ] SCRAPPING The unit is marked for conformity with European Directive 2012/19/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that the unit is scrapped properly, the user contributes to safeguarding the environment and public health. If the hood turns off during normal operation: Check that: In case of faulty operation, before contacting Technical least 5 seconds by pulling its plug, then reconnect it. [. . . ]