User manual HOTPOINT HHDC 9.7 CB X/HA

[. . . ] diventare molto calde se utilizzate con degli apparecchi di cottura. € Il presente apparecchio può essere • The cooker hood comes with anchor plugs which are suitable for use with utilizzato dai bambini a partire dagli most walls/ceilings. 8 anni e da persone con ridotte capacità fisiche, sensoriali o mentali oppure con mancanza di esperienza 8 However, you must contact a qualified technician to check the suitability of the materials in relation to the type of wall/ ceiling, which must be strong enough to support the weight of the unit. Do not hook the unit up to its electrical power supply until the installation has been completed. [. . . ] This version requires an air deflector, a reduction adapter and the charcoal filter/s. The top tube must have its air outlet slots uppermost. GB Electrical hook up The mains voltage must match that given on the ratings label inside the hood itself. If the hood has a power plug, connect the hood to an easily accessible regulatory power socket. If it does not (direct connection to the mains), or the socket is not easily accessible, install a two-pole regulatory switch to enable total disconnection from the mains in case of category III overvoltage, as required by the installation regulations. Always check that the mains cable is hooked up properly and check that it operates correctly before reconnecting the hood to the mains. Air exhaust (for ducted units) Connect the hood to a duct and wall exhaust hole of a diameter equal to that of the air outlet flange. Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also increases its running noise. The manufacturer is not liable for any consequences of doing so. Use the shortest duct required to achieve the purpose. Use a duct with as few bends as possible !Avoid suddenly changing the diameter of the duct. The duct must have as smooth an inner surface as possible. The duct must be made of regulatory material. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, chimneys, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. Of exhaust tube (cm) 15/12 Please check the plate in order to verify the total absorption and the light absorption Power Halogen 25 W 2 x 25 W Voltage 230 V Cap G9 Dimensions L40xØ14 The model is in accordance with the following EU directives: • “Low voltage” Directive 2006/95/EC (12-12-2006) • “EMC” Directive 2004/108/EC (15-12-2004) UR Reference no. If you wish to use it as a filter unit, you must install the proper ACCESSORY KIT. Note: If supplied with the hood, the accessory active charcoal filter unit may already be installed. [. . . ] Assembly: Secure the activated-carbon filter first in the back using the hood's metal tabs and then in the front by pressing the two If something does not work, make the following simple checks before contacting Technical Service: If the hood does not operate: Check that: • the unit is powered up. If the hood is not working effectively: Check that: • the selected motor speed is sufficient to handle the amount of smoke and steam being produced. € the kitchen is adequately ventilated for the unit to take air in. € the charcoal filter is not exhausted (filter version). [. . . ]