User manual HOTPOINT HLC 9.8 ATI X

[. . . ] If the installation instruction manual for the gas cooking appliance specifies a greater distance, this measurement should be taken into account. € The cooker hood comes with anchor plugs which are suitable for use with most walls/ceilings. However, you must contact a qualified technician to check the suitability of the materials in relation to the type of wall/ ceiling, which must be strong enough to support the weight of the unit. Do not hook the unit up to its electrical power supply until the installation has been completed. [. . . ] Instructions for transforming the hood from the ducted to the filter version are given in this manual (see “Filter version”(. * Only available in certain models 16 CHIMNEY-LUCE controls Models with Touch control glass (basic) HLC 9. 8 ATI X Hood off The hood can be turned off manually by pressing the T1 button )ON/OFF). If the timer is set, the hood turns off automatically when the set time runs out. GB Models with Touch control glass + display (medium) T5 T6 T7 T8 )Only available in certain models) T1 T2 T3 T4 T1 motor ON/OFF When the button is pressed with the hood off, the first speed is set. When the button is pressed during operation, the hood switches OFF. T2 Speed 1 When the button is pressed the hood switches from the previous status to speed 1. T3 Speed 2 When the button is pressed the hood switches from the previous status to speed 2. T4 Speed 3 When the button is pressed the hood switches from the previous status to speed 3. T5 Booster When the button is pressed the hood switches from the previous status to intense speed. The setting is limited by time; when the time elapses the hood goes back to the speed set previously; when a speed button is pressed )T2, T3 or T4), the selected speed is set as you leave the booster mode. Hood off The hood can be turned off manually by pressing the T1 button )ON/OFF). If the hood stays on in manual mode, it turns off automatically after a certain “safety” time. If the timer is set, the hood turns off automatically when the set time runs out. T5 AUTO Press the T5 button to activate the automatic mode, which turns the hood on based on the steam level detected. While in normal operation the sensor regulates the motor speed within the admitted values )0, 1, 2, 3 or booster). The hood switches from automatic to manual mode when the Booster or Speed button is pressed. The sensor needs calibrating before use; for more information please refer to paragraph “Calibration procedure” T6 Timer “–” With the timer, a time can be set, after which the hood turns OFF; if the timer is set and the speed is subsequently changed by pressing T2, T3 or T4, the timer is deactivated. Press the T6 button to decrease the previously set value by 5 minutes. T7 Timer “+” When the button is pressed for the first time, the timer is set to 5 minutes; this value is increased by 5 additional minutes every time the button is pressed after that. T8 lights ON/OFF It turns the work lights of the hood on and off. I1 D1 D2 I5 Models with Touch control glass + display (high) )Only available in certain models) I2 D1: DGT Speed D2: Assembly of 2 DGT Time I1: Grease Filter Indicator I2: Carbon Filter Indicator I4: Menu Indicator I5: Timer Indicator I4 T1 T2 T3 T4 T5 T6 T7 T8 T1 motor ON/OFF When the button is pressed with the hood off, the first speed is set. [. . . ] The manufacturer is not liable for any damage to the motor or fires caused by incorrect care or failure to follow the above instructions. 19 GB Servicing the grease filter (A) The grease filter retains the particles of grease produced during cooking; it must be cleaned at least once a month with a non-aggressive detergent, either by hand or with a low temperature, short A dishwasher cycle. To extract the grease filter, pull the spring loaded handle. If washed in a dishwasher, the metal filter may change colour, but this does not affect its performance. [. . . ]