User manual HOTPOINT HO 97 P.1/E IX

[. . . ] 18 Congratulations on choosing an Ariston appliance, which you will find is dependable and easy to use. We recommend that you read the instructions in this owner’s manual carefully before use for the best performance and to extend the life of your appliance, as it will provide you with all the instructions you require to ensure its safe installation, use and maintenance. Always keep this owner’s manual close to hand since you may need to refer to it in the future. Control Panel Dripping Pan or Baking Sheet Oven Rack Electric hotplate Cooking mode selection knob Electric hotplate knobs Electric hotplate indicator light Guides for sliding the racks or dripping pan in and out I. [. . . ] You will notice some white dust deposits on the bottom and sides of your oven; remove them with a damp sponge once the oven has cooled down completely. You may on the other hand prefer to take advantage of the heat accumulated to start cooking immediately; in this case the dust can stay where it is: it is completely harmless and will not affect your food in any way. Notice: during the automatic cleaning cycle, the surfaces may become very hot. How to enable the fast clean function – Shut the oven door. € To programme the fast clean cycle time and/or cycle end time, follow the instructions provided in the paragraph entitled “Fast clean programming”. Please note that you can choose a cycle time of between 60 and 120 minutes, depending on the degree of soil in your oven. Programming the fast clean cycle time Press button 5 and then adjust the cycle time by turning knob C. Press the OK button to store the setting. The time left until the end of the fast clean cycle will be displayed. Once this time is up, the word “end” will be displayed and a sequence of acoustic signals will be sounded to indicate that the cleaning cycle is complete. € Press any button to silence the acoustic signal. € Turn knob B back to position 0 to remove the word “end” from the display. And the fast clean cycle end time is set at 10:15 a. Fast clean will last 1 hour and 15 minutes. And a fast clean cycle time of 1 hour and 15 minutes is programmed. The fast clean cycle will end automatically at 10:15 a. Programming the fast clean cycle end time Press button 4 and then adjust by turning knob C. Press the OK button to store the setting. The time left until the end of the fast clean cycle will be displayed. When the fast clean cycle time previously selected is up, the word “end” will be displayed and a sequence of acoustic signals will be sounded to indicate that the fast clean cycle is complete. € Press any button to silence the acoustic signal. € Turn knob B back to position 0 to remove the word “end” from the display. [. . . ] 31 BUILT-IN HOB Only on certain models P N L3 L2 Fig. E BLUE WHITE RED YELLOW GREEN L1 230V 1N~ H07RN-F 3x4 CEI-UNEL 35364 N L BUILT-IN COOKER Fitting on a Power Supply Cable Opening the terminal board: • Using a screwdriver, prise on the side tabs of the terminal board cover; • Pull open the cover of the terminal board. F To install the cable, proceed as follows: • unscrew the wire clamp screw and the contact screws Note: the jumpers are factory-set for a three-phase 400V connection (fig. G, use the two jumpers housed in the box (fig. [. . . ]