User manual HOTPOINT KBM 6002 DH CL

[. . . ] If you have any doubts, call in a qualified technician to check the electrical system thoroughly. €¢ The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. €¢ Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. €¢ Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. [. . . ] Deformations due to improper fastening could alter the characteristics of the hob and compromise its performance. The fastening springs are fastened by screws (see diagram). It is vital that these screws be kept accessible at all times. Insert the hob into the cut-out slot, applying pressure all along the perimeter of the hob frame so that the latter adheres fully to the worktop. Installation • This hob can be built into a worktop simply by cutting out the corresponding slot. €¢ The worktop must be made with a material designed to withstand a temperature of approximately 100°C. €¢ The hob should be positioned at least 40 mm (for mod:KBM 6011DH - KBM 6001 H the hob should be positioned at least 55 mm) away from the back wall or any other vertical surface in order to allow for correct ventilation and to prevent the surfaces around the appliance from overheating. €¢ If you wish to install the hob on top of an oven, the latter must be fitted with a cooling fan. €¢ Try to avoid installing the hob on top of a dishwasher; if this is unavoidable, place a watertight separating element between the two appliances. REAR SPRING ASSEMBLY FRONT OF HOB KITCHEN WORKTOP 30 574 50 4 10 mm 48 Distance to keep between the cut-out slot and the cabinet HOB FROM BELOW 56 0+ /- 1 49 0+ /- 1 40 Technical characteristics Electrical connection • The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. Always ensure that this vital safety measure has been taken. If you have any doubts, call in a qualified technician to check the electrical system thoroughly. €¢ The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. €¢ Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. €¢ Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. if in doubt , contact a qualified professional. Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. if in doubt , contact a qualified professional. The cable provided is not suitable for the following types of installation. [. . . ] Do this as soon as possible, do not wait for the hob to cool down in order to avoid incrustations. For excellent results, use a special stainless steel wool pad for vitroceramic glass cleaning soaked in soapy water. €¢ When the hob is clean, you can apply a special product for the care and protection of the same: this type of product leaves an invisible film on the surface of the hob to protect the same against any spills and boiled-over food. It is best if you do this when the hob is lukewarm or cold. [. . . ]