User manual HOTPOINT KBT 6004 I CL

[. . . ] If you have any doubts, call in a qualified technician to check the electrical system thoroughly. € The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. € Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. € Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. [. . . ] REAR SPRING ASSEMBLY FRONT OF HOB KITCHEN WORKTOP 30 574 48 50 4 56 0+ /- 1 4 + 90 /- 1 HOB FROM BELOW 10 mm Distance to keep between the cut-out slot and the cabinet 40 Technical characteristics Electrical connection • The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in compliance with regulations on electrical safety. Always ensure that this vital safety measure has been taken. If you have any doubts, call in a qualified technician to check the electrical system thoroughly. € The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly. € Before powering the appliance, check whether the technical characteristics featured on the appliance data plate correspond with those of the mains electrical system. € Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the appliance, indicated on the appliance data plate. if in doubt , contact a qualified professional. Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. if in doubt , contact a qualified professional. The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. Single-phase connection The hob is equipped with a preconnected electricity supply cable, which is designed for single-phase connection. if in doubt , contact a qualified professional. Unlike traditional cooking zones, the induction zone does not heat up the glass surface. The pan itself is the heating element: the pan evenly transfers heat to its contents as long as it is made of ferromagnetic material. if in doubt , contact a qualified professional. As long as the temperature of the cooking zones remains above 60°C, even after use, the residual heat indicators stay on(the power display indicates H) to prevent the risk of burns. Power (from 0 to 9) and residual heat indicators (H) 4. Lock indicator light 0 0 3 6 5 1 7 8 30 Operation When you connect the hob to the power supply, a beep will sound after a few seconds: you can now turn the hob on. [. . . ] The concentration of heat on gas burners can warp the bottom of the pan, consequently you would never obtain the desired result when using the pan on the glass ceramic hob. Never leave a cooking zone on without a pan on it as the maximum heat level would be reached very quickly, which could damage the heating elements. the glass ceramic hob is resistant to thermal and mechanical shocks. However, it may break due to a shock caused by a sharp object. [. . . ]