User manual HOTPOINT KBT 8424 IDO IX 400

[. . . ] € Before using the appliance, read the instructions in the owner’s manual carefully since it contains all the instructions you require to ensure safe installation, use and maintenance. Keep this owner’s manual in a safe place for future reference. € When you have removed the packing, check whether the appliance is intact. If you have any doubts, contact a qualified professional before using the appliance. [. . . ] Disconnect the appliance from the electricity supply before all operations. Connect your hob to the electrical system by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed. Valid only for models with a power supply cable Some models are supplied with a single-phase power supply cable, and should consequently only be connected to the singlephase mains. Observe the wire colours, as indicated in the diagram attached. Collegamenti elettrici Tensione Frequenza Fusibili Sezioni To install the cable, proceed as follows: • unscrew the wire clamp screw and the contact screws. € to make the desired electrical connection (see table), use the jumpers housed inside the box. Position the power supply cable wires according to the indications in the table. € once the connections have been made, tighten all the terminal screws fully. € Fasten the supply cable in place with the clamp and close the cover of the terminal board. N L FR-BE-AT-DE-GR-ES-ILIT-NZ-PT-GP-CH-MA-LUIE-FI-SE-IS-GB-NL-DK 230V - 1+N~ 50Hz CY-MT-AU-NZ-KW 240V - 1+N~ 50Hz 25A * 2, 5 mm² BL BR This appliance conforms with the following European Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments; - 2002/96/EC The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. To connect the cable, proceed as follows: • Using a screwdriver, prise on the side tabs of the terminal board cover; • Pull open the cover of the terminal board. 1 2 L1 3 4 5 L2 25 A* 2, 5 mm² 1 L1 2 L2 3 4 5 N 16 A* 1, 5 mm² 1 L1 2 L2 3 4 5 L3 16 A* 1, 5 mm² 16 A* 1, 5 mm² 25 A* 2, 5 mm² 1 L1 2 L2 3 4 N1 5 N2 1 2 L 3 4 5 N * Application of the simultaneity coefficient in accordance with cei 60335-2-6 norm 28 Cooking zone description Induction is the fastest cooking method available. Unlike traditional cooking zones, the induction zone does not heat up the glass surface. The pan itself is the heating element: the pan evenly transfers heat to its contents as long as it is made of ferromagnetic material. if in doubt , contact a qualified professional. As long as the temperature of the cooking zones remains above 60°C, even after use, the residual heat indicators stay on(the power display indicates H) to prevent the risk of burns. Power (from 0 to 9) and residual heat indicators (H) 4. Indicator light corresponding to the programmed cooking zone 10. Lock indicator light 1 11 12 Note • The timer control key (7), the cooking time indicator (8) and the zone indicator light (9) are only fitted on hobs featuring one or more timers (KBT 8424 IDO 400 - KBT 8424 IDO - KOT 7424 IO 400 - KOT 7424 IO - KBT 6114 ID - KBT 6124 ID 400 - KBT 6124 ID - KBT 6323 IO - KBT 6104 I CL). [. . . ] € Make sure you always rinse the hob with clean water and dry it thoroughly: otherwise the cleaning products could become encrusted onto the hob during subsequent cooking. Recommendations • Never use abrasive or corrosive substances, such as aerosol cleaners for grills and ovens, stain removers or rust removers, scouring powders and abrasive sponges: even the delicate ones could scratch the hob surface irreversibly. € We recommend you keep all items which could melt away from the hob, such as plastic utensils, sugar or products with a high sugar content. € Use this hob exclusively for cooking. [. . . ]