User manual HOTPOINT KM 6002 H

[. . . ] Make sure this basic safety requirement has been complied with. If in doubt, have it checked by a qualified technician. The manufacturer will not be held liable for damages caused by the improper earthing of the appliance. 6 Before connecting the appliance, make sure the specifications on the rating plate correspond to those of your power supply. [. . . ] Therefore, the cooktops cannot be installed alongside of cabinets which are higher than the surface of the cooktop itself. The following precautionary measures should be observed in order to ensure proper installation: a) Hoods must be installed in compliance with the required specifications contained in the instruction manual for the hood itself. B) The built-in ceramic glass top can be installed on any counter top as long as it is 600 mm or more in width and resistant to temperatures of up to 100°C. The dimensions and the position of the hole are shown in fig. 595 The four securing springs are held in place by 4 Torx screws. To remove the hob unit from its housing, undo the 2 Torx screws at the front, then the 2 Torx screws at the rear. The 4 screws should be accessible at all times for this purpose. REAR SPRING ASSEMBLY REAR LEFT MOUNTING REAR RIGHT MOUNTING 30 WORK SURFACE FRONT OF THE HOB UNIT HOB UNIT FACE DOWN FRONT LEFT MOUNTING FRONT RIGHT MOUNTING SEAL MOUNTING FRONT / REAR RIGHT / LEFT MOUSSE 5x8 mm 48 20 51 0 Leave this much space between the bottom and the cabinetry 56 0+ /- 1 49 0+ /- 1 X (CEI 335-2-6) The aforementioned measurements must absolutely be observed in so far as improper installation can cause the surrounding surface areas to overheat. It is recommended that the cooktop be installed at a distance of at least 40 mm from the back wall or other vertical surfaces to ensure that the air circulates properly over the cooking area and to avoid overheating the surrounding surfaces. A seal or gasket is provided with the cooktop; make sure that it adheres properly to the bottom par t of the frame of the cooktop. It is indispensable that the seal fits properly around the entire cooktop frame and especially along the corners in order to create a seal between the counter top and the cooktop itself so as to prevent spills or splashes from leaking into the cabinet below. Very important It is essential to install the hob on a totally flat surtace. Any damage caused by incorrect fitting may alter the characteristics or impair performance. Insert the cooktop into the hole, pressing firmly around the frame to make it adhere to the counter top. Make certain that the seal around the outside edge of the hob is correctly installed in order to avoid any leakage into the cabinetry below. 8 c) If a wooden panel is installed beneath the cooktop for insulation purposes, it must be positioned at least 20 mm from the bottom part of the cooktop itself. Note: If the cooktop is installed above a built-in oven, it is preferable that the oven be installed in such a way that it is set on two strips of wood; if, on the other hand, the oven is installed on a continuous base, there must be an opening in the back of at least 45 x 560 mm. If the cooktop is installed above a built-in oven not equipped with a forced air cooling system, air intake and exhaust slots must be provided to ensure that the air circulates properly within the cabinet. Detail of wiring - Connect the 5 wires to your machine respecting the colour of the wires and their connections. Black Blue Brown Black Green / Yellow The electrical safety ot this appliance is guaranteed only if the appliance is correctly earthed in compliance with the standards of electrical safety. The manufacturer can under no circumstances be considered responsible for any damage that might occur due to incorrect earthing of the appliance. Important points Your hob unit is supplied with a special Scholtès connection cable. [. . . ] The surface of the cooktop must be cleaned regularly with a solution of warm water and non-abrasive soap. Products specifically designed for cleaning the surfaces of ceramic glass cooktops must be used on a periodic basis. First, remove all residue and grease with a scraper used for cleaning purposes, such as (not supplied). Clean the cooktop when it is warm, using a suitable cleaning product and paper towels, then rub with a damp cloth, and dry. [. . . ]