User manual HOTPOINT KRA 640 C

[. . . ] It contains important information concerning the safe operation, installation and maintenance of the appliance.  Please keep these operating instructions for future reference. Pass them on to any new owners of the appliance.  The appliance must be installed by a qualified professional in accordance with the instructions provided. [. . . ] - button: the power of the cooking zone 4. Set the cooking duration using the buttons. Confirm by pressing the - + and Power function The power function for the cooking zones may be used to shorten heating-up times. Activate and set the power level for the desired cooking zone as described in the previous paragraph. Press and hold the selector button corresponding to the desired cooking zone for at least 2 seconds. The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. 33 GB Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will be switched on. The lights corresponding to the other hotplates programmed will flash. To display the time remaining for the other programmed hotplates, press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. The control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Switching off the hob Press the button to switch the appliance off. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. “Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. • Press and hold the simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. [. . . ] 37 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. If water is spilt on the surface, dry it quickly and thoroughly. [. . . ]