User manual HOTPOINT KRO 642 D C

[. . . ] 1 INCREASE TIME button increases the time value set on the timer (see Start-up and use). 2 DECREASE TIME button decreases the time value set on the timer (see Start-up and use). 3 COOKING ZONE SELECTOR button shows a particular cooking zone has been selected and therefore various adjustments are possible. 4 COOKING ZONE SELECTOR button is used to select the desired cooking zone. [. . . ] € To begin operating a cooking zone, press the corresponding control button and set the desired power level using the power level selector buttons between 0 and 9. All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Select the cooking zone using the corresponding selector button. Adjust the power level of the cooking zone. Press the light corresponding to the selected zone will start flashing. Set the cooking duration using the buttons. - + and Power function The power function for the cooking zones may be used to shorten heating-up times. Activate and set the power as described in level for the desired cooking zone the previous paragraph. Press and hold the selector button corresponding to the desired cooking zone for at least 2 seconds. The display, the power level indicator, will alternately show the letter “P” and the power level set previously until the desired power level has been reached. Once this level has been reached, the display will revert to showing the set power level. Confirm by pressing the selection occurs after 10 seconds. The timer begins counting down immediately. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. To visualise the time remaining for the other programmed 10 hotplates, press the button repeatedly: the time remaining for each hotplate will be shown sequentially in a clockwise order, starting from the front left hotplate. Changing the programme button repeatedly until the duration 1. Use the buttons to set the new duration. Press the button to switch the appliance off. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. [. . . ] This maintenance task should be carried out while the appliance is warm (not hot) or cold. € Always remember to rinse the appliance well with clean water and dry it thoroughly: residues can become encrusted during subsequent cooking processes. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. After cleaning, it is advisable to rinse the surface well and dry it thoroughly. [. . . ]