User manual HOTPOINT KZT 6013 T F/HA

[. . . ] IT Piani cottura Zone di cottura Posteriore dx Anteriore dx Posteriore sx Anteriore sx Centro sx Potenza totale KZT 6013 T F/HA Potenza (in W) Diametro (in mm) R 1800 R 600 RT 750/1750/2700 180 100 270 5100 6600 R = radiante singolo, RD = radiante doppio, RT = radiante triplo KZT 6114 D F/HA Potenza (in W) Diametro (in mm) R 1400 160 R 1800 180 RD 1000/2200 210 R 1200 1400 11 Operating Instructions HOB Contents IT Italiano, 1 GB GB English, 12 FR Français, 23 Installation, 13-15 Positioning Electrical connection Description of the appliance, 16-17 Control panel Extendable cooking zones ES Espanol, 34 Start-up and use, 18-19 KZT 6013 T F/HA KZT 6114 D F/HA Switching on the hob Switching on the cooking zones Switching on the extendable cooking zones Switching off the cooking zones Programming the cooking time Control panel lock Switching off the hob Practical advice on using the appliance Safety devices Precautions and tips, 20 General safety Disposal Care and maintenance, 21 Switching the appliance off Cleaning the appliance Disassembling the hob Technical description of the models, 22 Installation  Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance.  Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] • DOUBLE HOTPLATE ON indicator light shows the double hotplate has been switched on. gB DOUBLE PLATE ON button DOUBLE PLATE ON indicator light • TRIPLE HOTPLATE ON button switches on the triple hotplate (see Start-up and use). • TRIPLE HOTPLATE ON indicator light shows the triple hotplate has been switched on. TRIPLE PLATE ON button TRIPLE PLATE ON indicator light 17 Start-up and use GB  The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. Switching off the cooking zones • Press the button: the power of the cooking zone will progressively decrease until it is switched off. And buttons may be • Alternatively, the pressed simultaneously. This immediately returns the power setting to 0 and the cooking zone switches off.  A few seconds after the hob is connected to the electricity supply, all the lights and indicators on the control panel will switch on for a few seconds and a short buzzer will sound. It will be possible to switch on the hob only after the lights and indicators have switched off. Programming the cooking time  All the cooking zones may be programmed for a length of time between 1 and 99 minutes. Switching on the hob To switch the hob on, press and hold the for approximately one second. Select the cooking zone using the corresponding selector button. Set the cooking time using the “-” and “+” buttons. The timer begins counting down immediately. A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Repeat the above procedure for each hotplate you wish to programme. Switching on the cooking zones Each cooking zone is controlled by a device consisting of two buttons (- and +). • Press the button to activate the hotplate, then set the power to the level required using the and buttons. • To set the power to maximum, hold down the button briefly. Control panel lock When the hob is switched on, it is possible to lock the oven controls to avoid accidental changes being made to the settings (by children, during cleaning, button to lock the control panel: etc. [. . . ] If water is spilt on the surface, dry it quickly and thoroughly.  Some hobs have an aluminium frame which is GB Cleaning the appliance  Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. Never use steam cleaners or pressure cleaners on the appliance. [. . . ]