User manual HOTPOINT LFK 7M116 FR

[. . . ] The standard cleaning cycle corresponds to the Eco cycle. 2) Based on 280 standard cleaning cycles using cold water fill and the consumption of the low power modes. Actual energy consumption depends on how the appliance is used. 3) Based on 280 standard cleaning cycles. [. . . ] If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved. Only use detergent which has been specifically designed for dishwashers. Using excessive detergent may result in foam residue remaining in the machine after the cycle has ended. The use of tablets is only recommended for models which offer the MULTI-FUNCTIONAL TABLETS option. To achieve the best results from each washing and drying cycle, powder detergent, liquid rinse aid and salt should be used. Changing a wash cycle in progress If a mistake was made in the wash cycle selection process, it is possible to change the cycle provided that it has only just begun: once the wash cycle has started, in order to change the wash cycle switch off the machine by pressing and holding the ON/ OFF/Reset button. Switch it back on using the same button and select the desired wash cycle and options. Adding extra crockery Press the Start/Pause button and open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the Start/Pause button: The cycle will start again after a long beep has been emitted. If the delayed start has been set, at the end of the countdown the wash cycle will not start. Press the Start/Pause button to pause the machine; the wash cycle is stopped. At this stage it is not possible to change the wash cycle. Accidental interruptions If the door is opened during the wash cycle or there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Based on the different conditions of use, the wash-cycle duration and data can change. The number and type of wash cycles and options may vary depending on the dishwasher model. Wash cycles which include drying Yes EN Instructions on wash-cycle selection and detergent dosage Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. 25 gr/ml – 1 Tab Economical and fast wash for delicate items which are sensitive to high temperatures - run immediately after use (glassware in the upper rack + fragile dishes in the lower rack). 35 gr/ml – 1 Tab Economical and fast wash to be used for lightly soiled dishes - run immediately after use (2 dishes + 2 glasses + 4 pieces of cutlery + 1 saucepan + 1 small frying pan). 25 gr/ml – 1 Tab Pre-wash while awaiting completion of the load with the dishes from the next meal. no detergent Wash cycle Options Approximate duration of wash cycles Eco 50°* Delayed start – Tabs Half Load – Extra Dry 3:10’ Auto Intensive Yes Delayed start – Tabs Half Load – Extra Dry 2:30’ Auto Normal Yes Delayed start – Tabs Half Load – Extra Dry 2:00’ Auto Fast No Delayed start – Tabs - Half Load 1:00’ Delicate Yes Delayed start – Tabs Half Load – Extra Dry 1:40’ Express 30’ No Delayed start – Tabs 0:30’ Soak No Delayed start Half Load 0:12’ ** Quantity of pre-washing detergent. ECODESIGN REGULATION ECO wash cycle is the standard cycle to which the energy label data refers; this cycle can be used to wash crockery with a normal soil level and is the most efficient in terms of energy and water consumption for this type of crockery. [. . . ] € The rinse aid has been used up or the dosage is too low. The dishes and glasses are streaked or have a bluish tinge. The crockery has not been dried properly. • The rinse aid dosage is too high. [. . . ]