User manual HOTPOINT MBP 1912 F

[. . . ] 00 03/2006 I 12 Operating Instructions REFRIGERATOR/FREEZER COMBINATION Contents I Italiano, 1 GB GB English, 13 NL Nederlands, 25 Installation, 14 Positioning and connection Reversible doors Description of the appliance, 15-16 Control panel Overall view PT Portuges, 37 CS Ðóññêèé, 49 Accessories, 17 Refrigerator compartment Freezer compartment Start-up and use, 18-19 Starting the appliance Using the display Chiller system Using the refrigerator to its full potential Using the freezer to its full potential MBP 1912 F Maintenance and care, 20 Switching the appliance off Cleaning the appliance Avoiding mould and unpleasant odours Replacing the light bulb Changing the odour filter Precautions and tips, 21 General safety Disposal Respecting and conserving the environment Troubleshooting, 22 Assistance, 23 13 Installation GB !Before operating your new appliance please read these instructions carefully. They contain important information for safe use, installation and care of the appliance. Please keep these operating instructions for future reference. [. . . ] The temperature values that may be selected for the refrigerator compartment are +12°C, +7°C, +6°C, +5°C, +4°C, +3°C and +2°C, while the values that may be set for the freezer are -18°C, -19°C, 120°C, -21°C, -22°C, -24°C and -26°C. unusual temperature increase in the freezer compartment (see Troubleshooting). 18 Chiller system No Frost This system can be recognised by the aeration cells located on the back walls of each compartment. The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. The system maintains an optimal humidity level in the compartment, preserving the original quality of the food, preventing the food from sticking together and making defrosting a thing of the past. Do not block the aeration cells by placing food or containers in direct contact with the refrigerating back panel. Using the freezer to its full potential • Adjust the temperature using the display. € To freeze foods in safely and correctly, follow the instructions below: place the food in the FREEZER and STORAGE compartment, making sure that it does not come into contact with any food that has already been frozen; press the rapid-freezing SUPER FREEZE button (the corresponding LED lights up) and close the door. If this procedure is not followed, the alarm may sound. This alarm does not indicate a malfunction. To restore normal operation, hold the ON/OFF button down for more than two seconds. To disconnect the appliance, follow points 1 and 2 above. Replacing the light bulb To replace the light bulb in the refrigerator compartment, disconnect the plug from the electricity mains. Access the light bulb as shown (see diagram) and replace it with a similar light bulb, the power of which should not exceed 10 W. Changing the odour filter Cleaning the appliance • The external and internal parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. € The back of the appliance may collect dust. This can be removed by carefully using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug disconnected from the electricity mains before it is cleaned. The filter should be replaced approximately 6-8 months after it has been activated. This period may vary depending on the type of food stored inside the refrigerator. For information on where a replacement filter may be purchased, contact Assistance (see Assistance). To replace the filter, follow the instructions (see diagrams A and B). [. . . ] To switch off the buzzer, press the RESET ALARM button. Press a second time to display the set value on the freezer status bar, switch off the ALARM LED and restore normal operation. € • • • The doors do not close properly or the seals are damaged. The temperature that has been set is too high (see Start-up and use). [. . . ]