User manual HOTPOINT MF IDC AX0

[. . . ] This appliance may be used by children over the age of 8 and by persons with reduced physical, sensory and mental capacities, and by persons unfamiliar with its operation, under supervision or following instruction in the use of the appliance, on condition that they fully understand the risks associated with the appliance and the precautions required to operate it. Children may not play with the appliance. The appliance and its power cord must be kept out of the reach of children under the age of 8 at all times. Never leave the appliance unattended when it is plugged into an electrical outlet. [. . . ] Make sure that the mains voltage matches the appliance’s nameplate rating. This product is conforming with all mandatory CE Mark directives. FIRST USE Remove all packaging material and check that all accessory parts are present. When first using the appliance or after a long period of disuse, clean it thoroughly as indicated in the section Maintenance and cleaning. USER INSTRUCTIONS We recommend using long life (UHT) milk with a high fat content. For best results, take the milk out of the refrigerator immediately before using it. The bottom of the container and the contact area inside the base must be clean and dry. Selecting the whisk • • • Use the smooth whisk for heating the milk. Use the toothed whisk for frothing the milk, whether hot or cold. Store the whisk not in use in the holder on the back of the appliance. Always observe the minimum level marking and make sure the container is filled with at least 80 ml of milk. To froth the milk, fill the container with no more than 200 ml (lower maximum level marking ). To heat the milk, fill the container with no more than 400 ml (upper maximum level marking ). Filling amount • • • Setting the temperature • • • to froth the milk without heating it to froth or just warm up the milk (baby milk) to froth or just warm up the milk (cappuccino milk) • for making hot chocolate from powder For further details, see the Recipes booklet which can be downloaded on-line. remove the milk container’s lid. Fit the appropriate whisk into the holder on the bottom of the container. Pour the desired amount of milk into the container. Use the temperature knob to set the desired temperature. Insert the power plug into a suitable wall power outlet. The appliance will beep, the led will start flashing and the frother cycle will start. When the milk reaches the set temperature, the cycle automatically stops. If you set cold froth mode with the knob, the cycle will stop automatically after 60 seconds. [. . . ] The container, whisks and lid can be cleaned with hot water and a mild detergent, or in the dishwasher. Take care to dry all parts thoroughly before using them again. The heating base can be cleaned with a soft damp cloth which has been dipped in a small amount of detergent. Never immerse it in water or clean it in a dishwasher. [. . . ]