User manual HOTPOINT MM 060 DSL0

[. . . ] The use of attachments not recommended by the appliance manufacturer may cause injuries or damage. The appliance cannot be used to grind hard and/ or dry substances, otherwise the blade could be blunted. Do not let the cord hang over the edge of a table / counter or touch any hot surfaces. Do not use fingers to scrape food away from discharge outlet while appliance is operating. [. . . ] During operating, never unplug the power outlet to stop working directly. You must make sure the ON/OFF button is on the off position firstly, then unplug the power outlet. Never run the appliance empty after assembling the blade and blade tray. Otherwise the blade and blade tray will be abraded seriously, and accelerate the unit aging. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been provided supervision or instructions on the use of the appliance by a person responsible for en it their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance is intended for domestic use only. Save these instructions operates normally; put the meat piece into funnel, then press with the food pusher. Attention: Always ensure bones and rind are removed from the meat before mincing. OPERATING INSTRUCTIONS Note: Before the first use, please clean all the detachable parts such as food pusher, funnel, mincer head, die plate (large hole, medium hole, small hole), blade cover, blade, kibble cone, kibble shaper and so on completely. Note: Never assemble blade and mincer dieplates when making sausages, and do not assemble sausages filler’s nozzle and related support when grinding meat. Fix the mincer head into the motor unit. Press the lock button with one hand (see arrow 1 of picture 2), and hold the mincer head with the 2. 9 en it other hand, insert it into the hole of the unit and turn it counter-clockwise until it cannot move anymore (see arrow 2 of picture 2). Release the lock button and the mincer head is fixed on the motor unit: tighten the blade cover using the spanner to ensure all elements are securely in place. Set clean small intestine to sausage pole as in picture 6, then place minced meat into funnel. Press the ON/OFF button, the appliance turns anti-clockwise and the minced meat goes inside the intestine; you can tie the intestine anywhere you like with thread to make the sausage have proper length. CLEANING TIP: To remove the meat that is stuck in fine and medium mincer die-plates, align the holes of the die-plates with the blades-cleaning disc and push the bladescleaning disc into die-plate, as shown in picture 9. Any meat stuck in the die-plate will be pushed out. Any remaining meat that is still in the blade tray should be washed off using a soft sponge and hot soapy water. [. . . ] Any remaining meat that is still in the blade tray should be washed off using a soft sponge and hot soapy water. To remove foods from the die-plate (large hole), rinse it under cold, running water to force meat from holes, any remaining meat stuck on the blade tray should be washed off using a soft sponge and hot soapy water. Ensure that all attachments and discs are dried thoroughly before storing. If trays are not dried, rust may occur on the trays. [. . . ]