User manual HOTPOINT NMTL 1913 FW

[. . . ] This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Install in accordance with the Do not install near any heat sources such as radiators, heat registers, stoves, or Do not defeat the safety purpose of the polarized or grounding-type plug. Polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. [. . . ] If the cabinet is in contact with a rubber or vinyl resin product for a long period of time, the finish of the cabinet may deteriorate or the coating may come off. On disposal Do not dispose of this unit with ordinary garbage. Do not throw the monitor away with garbage that will be placed in a landfill. On this unit The top of this unit and the ventilation holes and metal parts may become hot after long use. Be very careful if holding this unit during or after use. During take-off and landing, follow the onboard instructions concerning this unit. Read this instruction manual together with the instruction manual of your camera. This unit is not dust-proof, splash-proof or waterproof. Do not place this unit in the following locations Regardless of whether this unit is in use or in storage, do not place it in any of the following locations. Placing this unit in locations subject to direct sunlight such as on dashboards or near a heater may cause this unit to deform or malfunction. Locations with excessive vibration Locations with strong electromagnetism Locations with excessive sand In locations such as the seashore and other sandy areas or where dust clouds occur, protect the unit from sand and dust. ¦Notes Do not disconnect or remove the battery or AC adaptor when turning This unit on or off (the power lamp flashes slowly). Just before the battery runs out, the power lamp turns red and flashes rapidly. The power to this unit automatically turns off about 10 seconds later. (When using this unit continuously at 25°C (77 °F) with a brand-new battery attached and connecting to the camera via HDMI) NP-FM500H: Approx. 8 hours * The battery life may differ from the above depending on operation status and environmental conditions. This unit can be powered from the domestic power supply using a Sony AC adaptor such as the AC-PW10AM (not supplied). ¦Notes A battery pack attached to this unit is not recharged even when an AC If this unit is connected to an AC adaptor while a battery pack is attached, The AC adaptor power source takes priority. ¦Note Do not attach a shoe adaptor except for this unit. Insert the tripod screw of the shoe adaptor into the tripod receptacle on the bottom of this unit. Attach (clip) the correct type of shoe adaptor onto the camera shoe, as illustrated. If using auto lock accessory shoe: Insert the foot of the shoe adaptor fully into the auto lock accessory shoe in the direction illustrated. [. . . ] Be careful when you pull the HDMI cable not to stretch it or get it caught Align the clips on the frame of the sun shade hood with the holes in the outer frame of this unit and attach, as illustrated. Fit the top part of the panel first and then press in the bottom part of the panel. Pull the bottom part of the sun shade hood frame towards you to remove it. A force applied to the top or side hood panels can detach them from the frame to prevent them from breaking. [. . . ]